[PATCH v4 32/75] x86/head/64: Load segment registers earlier
From: Joerg Roedel <joro@8bytes.org>
Date: 2020-07-14 12:15:38
Also in:
kvm, lkml
Subsystem:
the rest, x86 architecture (32-bit and 64-bit) · Maintainers:
Linus Torvalds, Thomas Gleixner, Ingo Molnar, Borislav Petkov, Dave Hansen
From: Joerg Roedel <redacted> Make sure segments are properly set up before setting up an IDT and doing anything that might cause a #VC exception. This is later needed for early exception handling. Signed-off-by: Joerg Roedel <redacted> --- arch/x86/kernel/head_64.S | 52 +++++++++++++++++++-------------------- 1 file changed, 26 insertions(+), 26 deletions(-)
diff --git a/arch/x86/kernel/head_64.S b/arch/x86/kernel/head_64.S
index 87ea9f540608..61aa1e56fc9c 100644
--- a/arch/x86/kernel/head_64.S
+++ b/arch/x86/kernel/head_64.S@@ -169,6 +169,32 @@ SYM_CODE_START(secondary_startup_64) movq %rax, boot_gdt_descr+2(%rip) lgdt boot_gdt_descr(%rip) + /* set up data segments */ + xorl %eax,%eax + movl %eax,%ds + movl %eax,%ss + movl %eax,%es + + /* + * We don't really need to load %fs or %gs, but load them anyway + * to kill any stale realmode selectors. This allows execution + * under VT hardware. + */ + movl %eax,%fs + movl %eax,%gs + + /* Set up %gs. + * + * The base of %gs always points to fixed_percpu_data. If the + * stack protector canary is enabled, it is located at %gs:40. + * Note that, on SMP, the boot cpu uses init data section until + * the per cpu areas are set up. + */ + movl $MSR_GS_BASE,%ecx + movl initial_gs(%rip),%eax + movl initial_gs+4(%rip),%edx + wrmsr + /* Check if nx is implemented */ movl $0x80000001, %eax cpuid
@@ -204,32 +230,6 @@ SYM_CODE_START(secondary_startup_64) */ lgdt early_gdt_descr(%rip) - /* set up data segments */ - xorl %eax,%eax - movl %eax,%ds - movl %eax,%ss - movl %eax,%es - - /* - * We don't really need to load %fs or %gs, but load them anyway - * to kill any stale realmode selectors. This allows execution - * under VT hardware. - */ - movl %eax,%fs - movl %eax,%gs - - /* Set up %gs. - * - * The base of %gs always points to fixed_percpu_data. If the - * stack protector canary is enabled, it is located at %gs:40. - * Note that, on SMP, the boot cpu uses init data section until - * the per cpu areas are set up. - */ - movl $MSR_GS_BASE,%ecx - movl initial_gs(%rip),%eax - movl initial_gs+4(%rip),%edx - wrmsr - /* rsi is pointer to real mode structure with interesting info. pass it to C */ movq %rsi, %rdi
--
2.27.0