# Re: \[PATCH 1/2\] net: phy: motorcomm: add led\_brightness\_set for YT8521

- From: Andrew Lunn \<andrew@lunn.ch\>
- Date: 2026-11-10 16:53:36 
- List: netdev
- Page: https://ratatoskr.run/netdev/2026/11/17907975
- Thread: https://ratatoskr.run/netdev/2026/11/17904676/t.md

```text
On Tue, Nov 10, 2026 at 06:00:00PM +0800, Chukun Pan wrote:
> Add support for manual brightness setting on YT8521/YT8531 PHY.

Has this been tested on real hardware? Have you had it blinking the
heartbeat? Shift-lock etc.

> --- a/drivers/net/phy/motorcomm.c
> +++ b/drivers/net/phy/motorcomm.c
> @@ -258,6 +258,10 @@
>  #define YTPHY_WCR_INTR_SEL			BIT(6)
>  #define YTPHY_WCR_ENABLE			BIT(3)
>  
> +#define YTPHY_LED_GENERAL_CFG_REG		0xA00B
> +#define YTPHY_LED_FORCE_MODE(x)			BIT((x) * 3)
> +#define YTPHY_LED_FORCE_EN(x)			BIT((x) * 3 + 2)
> +
>  /* 2b00 84ms
>   * 2b01 168ms  *default*
>   * 2b10 336ms

I _think_ this is the wrong place to insert these. 2b00 84ms refers to
YTPHY_WCR_PULSE_WIDTH_MASK which is used with YTPHY_WOL_CONFIG_REG? So
you insert these in the middle of WOL bits.

The sorting of registers is a bit messed up in this driver, but i
think you need to insert before:

#define YTPHY_PAD_DRIVE_STRENGTH_REG		0xA010

    Andrew

---
pw-bot: cr
```
