# Re: \[PATCH net-next v4 2/2\] net: wwan: qcom\_bam\_dmux: Assign restricted DMA pool to remote processor

- From: Loic Poulain \<loic.poulain@oss.qualcomm.com\>
- Date: 2026-11-03 16:04:46 
- List: netdev
- Page: https://ratatoskr.run/netdev/2026/11/17854394
- Thread: https://ratatoskr.run/linux-arm-msm/2026/11/17853261/t.md

```text
Hi Vishnu,

On Tue, Nov 3, 2026 at 3:19 PM Vishnu Santhosh
[ref] wrote:
>
> Some Qualcomm SoCs, such as Shikra, run the modem in a separate security
> domain with restricted access to system memory. BAM-DMUX DMA mappings
> and BAM descriptor FIFOs must therefore be constrained to a designated
> memory region that can be shared with the modem. Accesses outside that
> region can trigger an XPU violation.
>
> When qcom,vmid is present, require a restricted DMA pool and assign the
> entire pool to both the local and remote execution environments before
> requesting the DMA channels.
>
> This ensures that BAM-DMUX mappings are within the assigned region. When
> the BAM DMA controller references the same pool, its descriptor FIFOs
> are covered by the assignment as well.
>
> Track the assigned execution environments explicitly and reclaim the
> pool for the local environment after DMA channels and mappings are
> released during remove or probe error cleanup. Skip the reclaim and
> leave the pool assigned if the remote side still holds its power vote,
> since it may still access the pool.
>
> Fail probing when restricted DMA pool support is unavailable, when the
> VMID property is malformed, when memory-region does not reference a
> restricted DMA pool, or when the pool is not attached to the device.
>
> Co-developed-by: Deepak Kumar Singh <redacted>
> Signed-off-by: Deepak Kumar Singh <redacted>
> Signed-off-by: Vishnu Santhosh <redacted>
> ---
>  drivers/net/wwan/Kconfig         |   1 +
>  drivers/net/wwan/qcom_bam_dmux.c | 114 ++++++++++++++++++++++++++++++++++++++-
>  2 files changed, 113 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/net/wwan/Kconfig b/drivers/net/wwan/Kconfig
> index 958dbc7347fa84ee869439bf8b503037faab8bef..1b133c56231615269698140187ca3141dfe48dbf 100644
> --- a/drivers/net/wwan/Kconfig
> +++ b/drivers/net/wwan/Kconfig
> @@ -65,6 +65,7 @@ config MHI_WWAN_MBIM
>  config QCOM_BAM_DMUX
>         tristate "Qualcomm BAM-DMUX WWAN network driver"
>         depends on (DMA_ENGINE && PM && QCOM_SMEM_STATE) || COMPILE_TEST
> +       select QCOM_SCM
>         help
>           The BAM Data Multiplexer provides access to the network data channels
>           of modems integrated into many older Qualcomm SoCs, e.g. Qualcomm
> diff --git a/drivers/net/wwan/qcom_bam_dmux.c b/drivers/net/wwan/qcom_bam_dmux.c
> index cc6ace8d64371eb8d00c638a39b234ee540b83c9..c9639474e58acc16ce0d04f181b2e999cff42bd1 100644
> --- a/drivers/net/wwan/qcom_bam_dmux.c
> +++ b/drivers/net/wwan/qcom_bam_dmux.c
> @@ -9,14 +9,17 @@
>  #include <linux/completion.h>
>  #include <linux/dma-mapping.h>
>  #include <linux/dmaengine.h>
> +#include <linux/firmware/qcom/qcom_scm.h>
>  #include <linux/if_arp.h>
>  #include <linux/interrupt.h>
>  #include <linux/module.h>
>  #include <linux/netdevice.h>
> +#include <linux/of_reserved_mem.h>
>  #include <linux/platform_device.h>
>  #include <linux/pm_runtime.h>
>  #include <linux/soc/qcom/smem_state.h>
>  #include <linux/spinlock.h>
> +#include <linux/swiotlb.h>
>  #include <linux/wait.h>
>  #include <linux/workqueue.h>
>  #include <net/pkt_sched.h>
> @@ -75,6 +78,9 @@ struct bam_dmux {
>         struct completion pc_ack_completion;
>
>         struct dma_chan *rx, *tx;
> +       phys_addr_t dma_pool_base;
> +       size_t dma_pool_size;
> +       u64 dma_pool_perms;
>         struct bam_dmux_skb_dma rx_skbs[BAM_DMUX_NUM_SKB];
>         struct bam_dmux_skb_dma tx_skbs[BAM_DMUX_NUM_SKB];
>         spinlock_t tx_lock; /* Protect tx_skbs, tx_next_skb */
> @@ -762,6 +768,96 @@ static int __maybe_unused bam_dmux_runtime_resume(struct device *dev)
>         return 0;
>  }
>
> +static int bam_dmux_assign_dma_pool(struct bam_dmux *dmux)
> +{
> +       struct device *dev = dmux->dev;
> +       struct device_node *rmem_np;
> +       struct reserved_mem *rmem;
> +       struct qcom_scm_vmperm dst[2];
> +       u64 src = BIT_ULL(QCOM_SCM_VMID_HLOS);
> +       u32 vmid;
> +       int ret;
> +
> +       if (!of_property_present(dev->of_node, "qcom,vmid"))
> +               return 0;
> +
> +       ret = of_property_read_u32(dev->of_node, "qcom,vmid", &vmid);
> +       if (ret)
> +               return dev_err_probe(dev, ret, "Failed to read qcom,vmid\n");
> +       if (vmid == QCOM_SCM_VMID_HLOS || vmid >= BITS_PER_TYPE(u64))
> +               return dev_err_probe(dev, -EINVAL, "Invalid qcom,vmid %u\n", vmid);
> +
> +       if (!IS_ENABLED(CONFIG_DMA_RESTRICTED_POOL))
> +               return dev_err_probe(dev, -EOPNOTSUPP,
> +                                    "qcom,vmid requires DMA_RESTRICTED_POOL\n");
> +
> +       rmem_np = of_parse_phandle(dev->of_node, "memory-region", 0);
> +       if (!rmem_np)
> +               return dev_err_probe(dev, -EINVAL,
> +                                            "qcom,vmid requires memory-region\n");
> +
> +       if (!of_device_is_compatible(rmem_np, "restricted-dma-pool")) {
> +               of_node_put(rmem_np);
> +               return dev_err_probe(dev, -EINVAL,
> +                                    "memory-region must reference a restricted DMA pool\n");
> +       }

You later test with is_swiotlb_for_alloc(), so isn't the above test redundant?


> +
> +       rmem = of_reserved_mem_lookup(rmem_np);
> +       of_node_put(rmem_np);
> +       if (!rmem)
> +               return dev_err_probe(dev, -EINVAL,
> +                                            "Failed to look up restricted DMA pool\n");
> +
> +       if (!is_swiotlb_for_alloc(dev))
> +               return dev_err_probe(dev, -EINVAL,
> +                                    "Restricted DMA pool not attached\n");
> +
> +       if (!qcom_scm_is_available())
> +               return -EPROBE_DEFER;
> +
> +       dst[0].vmid = QCOM_SCM_VMID_HLOS;
> +       dst[0].perm = QCOM_SCM_PERM_RW;
> +       dst[1].vmid = vmid;
> +       dst[1].perm = QCOM_SCM_PERM_RW;
> +
> +       ret = qcom_scm_assign_mem(rmem->base, rmem->size, &src, dst,
> +                                 ARRAY_SIZE(dst));
> +       if (ret)
> +               return dev_err_probe(dev, ret,
> +                                    "SCM assign restricted DMA pool failed\n");
> +
> +       dmux->dma_pool_base = rmem->base;
> +       dmux->dma_pool_size = rmem->size;
> +       /* Track the destination VMIDs explicitly for the reclaim operation. */
> +       dmux->dma_pool_perms = BIT_ULL(QCOM_SCM_VMID_HLOS) | BIT_ULL(vmid);
> +
> +       return 0;
> +}
> +
> +static void bam_dmux_reclaim_dma_pool(struct bam_dmux *dmux)
> +{
> +       struct qcom_scm_vmperm hlos = {
> +               .vmid = QCOM_SCM_VMID_HLOS,
> +               .perm = QCOM_SCM_PERM_RW,
> +       };
> +       u64 src = dmux->dma_pool_perms;
> +       int ret;
> +
> +       if (!dmux->dma_pool_perms)
> +               return;
> +
> +       ret = qcom_scm_assign_mem(dmux->dma_pool_base, dmux->dma_pool_size, &src,
> +                                 &hlos, 1);
> +       if (ret) {
> +               dev_err(dmux->dev, "SCM reclaim restricted DMA pool failed: %d\n", ret);
> +               return;
> +       }
> +
> +       dmux->dma_pool_perms = 0;
> +}
> +
> +static void bam_dmux_remove(struct platform_device *pdev);
> +
>  static int bam_dmux_probe(struct platform_device *pdev)
>  {
>         struct device *dev = &pdev->dev;
> @@ -796,6 +892,10 @@ static int bam_dmux_probe(struct platform_device *pdev)
>                                      "Failed to get pc-ack state\n");
>         dmux->pc_ack_mask = BIT(bit);
>
> +       ret = bam_dmux_assign_dma_pool(dmux);
> +       if (ret)
> +               return ret;
> +
>         init_waitqueue_head(&dmux->pc_wait);
>         init_completion(&dmux->pc_ack_completion);
>         complete_all(&dmux->pc_ack_completion);
> @@ -829,8 +929,11 @@ static int bam_dmux_probe(struct platform_device *pdev)
>
>         ret = irq_get_irqchip_state(dmux->pc_irq, IRQCHIP_STATE_LINE_LEVEL,
>                                     &dmux->pc_state);
> -       if (ret)
> -               goto err_disable_pm;
> +       if (ret) {
> +               /* The PC IRQ may already have powered up the RX path */
> +               bam_dmux_remove(pdev);

Calling remove from probe is a bit unusual, have you checked that
everything is correctly balanced?

> +               return ret;
> +       }
>
>         /* Check if remote finished initialization before us */
>         if (dmux->pc_state) {
> @@ -845,6 +948,7 @@ static int bam_dmux_probe(struct platform_device *pdev)
>  err_disable_pm:
>         pm_runtime_disable(dev);
>         pm_runtime_dont_use_autosuspend(dev);
> +       bam_dmux_reclaim_dma_pool(dmux);
>         return ret;
>  }
>
> @@ -879,6 +983,12 @@ static void bam_dmux_remove(struct platform_device *pdev)
>         disable_irq(dmux->pc_irq);
>         bam_dmux_power_off(dmux);
>         bam_dmux_free_skbs(dmux->tx_skbs, DMA_TO_DEVICE);
> +
> +       /* The remote side may still access the pool if it holds its power vote */
> +       if (!dmux->pc_state)
> +               bam_dmux_reclaim_dma_pool(dmux);
> +       else if (dmux->dma_pool_perms)
> +               dev_warn(dev, "Leaving restricted DMA pool assigned to remote\n");
>  }
>
>  static const struct dev_pm_ops bam_dmux_pm_ops = {
>
> --
> 2.34.1
>
```
