# Re: \[PATCH net-next\] net: phy: micrel: Add support for lan9645x internal phy

- From: Jens Emil Schulz Ostergaard \<hidden\>
- Date: 2026-01-23 13:41:24 
- List: netdev
- Page: https://ratatoskr.run/netdev/2026/01/3384422
- Thread: https://ratatoskr.run/netdev/2026/01/3383752/t.md

```text
Hi Maxime,

On Fri, 2026-01-23 at 09:57 +0100, Maxime Chevallier wrote:
> 
> Hi Jens,
> 
> On 23/01/2026 08:50, Jens Emil Schulz Østergaard wrote:
> > LAN9645X is a family of switch chips with 5 internal copper phys.
> > The
> > internal PHY is based on parts of LAN8832. This is a low-power,
> > single
> > port triple-speed (10BASE-T/100BASE-TX/1000BASE-T) ethernet
> > physical
> > layer transceiver (PHY) that supports transmission and reception of
> > data
> > on standard CAT-5, as well as CAT-5e and CAT-6 Unshielded Twisted
> > Pair (UTP) cables.
> > 
> > Add support for the internal PHY of the lan9645x chip family.
> > 
> > Reviewed-by: Steen Hegelund <Steen.Hegelund@microchip.com>
> > Reviewed-by: Daniel Machon <daniel.machon@microchip.com>
> > Signed-off-by: Jens Emil Schulz Østergaard
> > [ref]
> > ---
> 
> [...]
> 
> > +static int lan9645x_config_intr(struct phy_device *phydev)
> > +{
> > +     int err;
> > +
> > +     /* enable / disable interrupts */
> > +     if (phydev->interrupts == PHY_INTERRUPT_ENABLED) {
> > +             /* This is an internal PHY of lan9645x and is not
> > possible to
> > +              * change the polarity of irq sources in the OIC
> > (CPU_INTR)
> > +              * found in lan9645x. Therefore change the polarity
> > of the
> > +              * interrupt in the PHY from being active low instead
> > of active
> > +              * high.
> > +              */
> > +             phy_write(phydev, LAN8804_CONTROL,
> > +                       LAN8804_CONTROL_INTR_POLARITY);
> > +
> > +             /* By default interrupt buffer is open-drain in which
> > case the
> > +              * interrupt can be active only low. Therefore change
> > the
> > +              * interrupt buffer to be push-pull to be able to
> > change
> > +              * interrupt polarity.
> > +              */
> > +             phy_write(phydev, LAN8804_OUTPUT_CONTROL,
> > +                       LAN8804_OUTPUT_CONTROL_INTR_BUFFER);
> 
> Small nit from me, you're missing error checks on the 2 above reads.
> 
> Thanks,
> 
> Maxime
> 

Thank you, I will add error checks in the next version.

Thanks,

Emil
```
