# Re: \[PATCH net-next\] net: phy: micrel: Add support for lan9645x internal phy

- From: Maxime Chevallier \<maxime.chevallier@bootlin.com\>
- Date: 2026-01-23 08:57:39 
- List: netdev
- Page: https://ratatoskr.run/netdev/2026/01/3383889
- Thread: https://ratatoskr.run/netdev/2026/01/3383752/t.md

```text
Hi Jens,

On 23/01/2026 08:50, Jens Emil Schulz Østergaard wrote:
> LAN9645X is a family of switch chips with 5 internal copper phys. The
> internal PHY is based on parts of LAN8832. This is a low-power, single
> port triple-speed (10BASE-T/100BASE-TX/1000BASE-T) ethernet physical
> layer transceiver (PHY) that supports transmission and reception of data
> on standard CAT-5, as well as CAT-5e and CAT-6 Unshielded Twisted
> Pair (UTP) cables.
> 
> Add support for the internal PHY of the lan9645x chip family.
> 
> Reviewed-by: Steen Hegelund <Steen.Hegelund@microchip.com>
> Reviewed-by: Daniel Machon <daniel.machon@microchip.com>
> Signed-off-by: Jens Emil Schulz Østergaard <redacted>
> ---

[...]

> +static int lan9645x_config_intr(struct phy_device *phydev)
> +{
> +	int err;
> +
> +	/* enable / disable interrupts */
> +	if (phydev->interrupts == PHY_INTERRUPT_ENABLED) {
> +		/* This is an internal PHY of lan9645x and is not possible to
> +		 * change the polarity of irq sources in the OIC (CPU_INTR)
> +		 * found in lan9645x. Therefore change the polarity of the
> +		 * interrupt in the PHY from being active low instead of active
> +		 * high.
> +		 */
> +		phy_write(phydev, LAN8804_CONTROL,
> +			  LAN8804_CONTROL_INTR_POLARITY);
> +
> +		/* By default interrupt buffer is open-drain in which case the
> +		 * interrupt can be active only low. Therefore change the
> +		 * interrupt buffer to be push-pull to be able to change
> +		 * interrupt polarity.
> +		 */
> +		phy_write(phydev, LAN8804_OUTPUT_CONTROL,
> +			  LAN8804_OUTPUT_CONTROL_INTR_BUFFER);

Small nit from me, you're missing error checks on the 2 above reads.

Thanks,

Maxime

```
