# Re: 回覆: \[net-next 2/4\] ARM: dts: ast2600-evb: add default RGMII delay

- From: Andrew Lunn \<andrew@lunn.ch\>
- Date: 2025-03-18 14:03:17 
- List: netdev
- Page: https://ratatoskr.run/netdev/2025/03/2976468
- Thread: https://ratatoskr.run/netdev/2025/03/2973597/t.md

```text
On Tue, Mar 18, 2025 at 11:00:27AM +0000, Jacky Chou wrote:
> Hi Andrew,
> 
> Thank you for your reply.
> 
> > >  	phy-mode = "rgmii";
> > >  	phy-handle = <&ethphy2>;
> > >
> > > +	tx-internal-delay-ps = <8>;
> > > +	rx-internal-delay-ps = <4>;
> > > +
> > 
> > Ideally you want:
> > 
> > 	phy-mode = "rgmii-id";
> > 	tx-internal-delay-ps = <0>;
> > 	rx-internal-delay-ps = <0>;
> > 
> > Since 'rgmii-id' correctly describes the hardware.
> 
> I still confuse about ethernet-controller.yaml.
> It lists 'rgmi', 'rgmii-rxid', 'rgmii-txid' and 'rgmii-id'.

DT describes the board. Does the board add the 2ns delay via extra
long clock lines? If yes, use rgmii. If the MAC/PHY pair need to add
the 2ns delay, use rgmii-id.

If the MAC/PHY pair is adding the delay, the DT says nothing about how
they add the delay.

The general rule is the PHY adds the delay. If you look at
drivers/net/phy/*.c, every PHY that implements RGMII support both
PHY_INTERFACE_MODE_RGMII_ID and PHY_INTERFACE_MODE_RGMII. There is no
reason not to follow ever other MAC/PHY pair and have the PHY add the
delay. The MAC can then do fine tuning if needed, adding small delays.

	Andrew
```
