[PATCH net-next 0/4] net: remove repeated words

@@ -510,7 +510,7 @@ static int mdiobus_create_device(struct mii_bus *bus,
  *   on a given bus, and attach them to the bus. Drivers should use
  *   mdiobus_register() rather than __mdiobus_register() unless they
  *   need to pass a specific owner module. MDIO devices which are not
- *   PHYs will not be brought up by this function. They are expected to
+ *   PHYs will not be brought up by this function. They are expected
  *   to be explicitly listed in DT and instantiated by of_mdiobus_register().
  *
  * Returns 0 on success or < 0 on error.

@@ -7339,7 +7339,7 @@ static void i40e_vsi_set_default_tc_config(struct i40e_vsi *vsi)
 	qcount = min_t(int, vsi->alloc_queue_pairs,
 		       i40e_pf_get_max_q_per_tc(vsi->back));
 	for (i = 0; i < I40E_MAX_TRAFFIC_CLASS; i++) {
-		/* For the TC that is not enabled set the offset to to default
+		/* For the TC that is not enabled set the offset to default
 		 * queue and allocate one queue for the given TC.
 		 */
 		vsi->tc_config.tc_info[i].qoffset = 0;

@@ -10625,7 +10625,7 @@ static void i40e_rebuild(struct i40e_pf *pf, bool reinit, bool lock_acquired)
 	 * need to rebuild the switch model in the HW.
 	 *
 	 * If there were VEBs but the reconstitution failed, we'll try
-	 * try to recover minimal use by getting the basic PF VSI working.
+	 * to recover minimal use by getting the basic PF VSI working.
 	 */
 	if (vsi->uplink_seid != pf->mac_seid) {
 		dev_dbg(&pf->pdev->dev, "attempting to rebuild switch\n");

@@ -1098,7 +1098,7 @@ static void alb_fasten_mac_swap(struct bonding *bond, struct slave *slave1,
  * If @slave's permanent hw address is different both from its current
  * address and from @bond's address, then somewhere in the bond there's
  * a slave that has @slave's permanet address as its current address.
- * We'll make sure that that slave no longer uses @slave's permanent address.
+ * We'll make sure that slave no longer uses @slave's permanent address.
  *
  * Caller must hold RTNL and no other locks
  */

@@ -809,7 +809,7 @@ static u32 hol_block_timer_val(struct ipa *ipa, u32 microseconds)
 	 * The best precision is achieved when the base value is as
 	 * large as possible.  Find the highest set bit in the tick
 	 * count, and extract the number of bits in the base field
-	 * such that that high bit is included.
+	 * such that high bit is included.
 	 */
 	high = fls(ticks);		/* 1..32 */
 	width = HWEIGHT32(BASE_VALUE_FMASK);

@@ -1448,7 +1448,7 @@ static int ipa_endpoint_reset_rx_aggr(struct ipa_endpoint *endpoint)
 	if (ret)
 		goto out_suspend_again;
 
-	/* Finally, reset and reconfigure the channel again (re-enabling the
+	/* Finally, reset and reconfigure the channel again (re-enabling
 	 * the doorbell engine if appropriate).  Sleep for 1 millisecond to
 	 * complete the channel reset sequence.  Finish by suspending the
 	 * channel again (if necessary).