# RE: \[PATCH V1 net-next 0/3\] net: stmmac: implement clocks

- From: Joakim Zhang \<hidden\>
- Date: 2021-02-25 01:43:59 
- List: netdev
- Page: https://ratatoskr.run/netdev/2021/02/11197377
- Thread: https://ratatoskr.run/netdev/2021/02/11197241/t.md

```text

> -----Original Message-----
> From: Florian Fainelli <f.fainelli@gmail.com>
> Sent: 2021年2月24日 11:54
> To: Joakim Zhang <redacted>; Jakub Kicinski
> [ref]
> Cc: <redacted>; <redacted>;
> joabreu@synopsys.com; davem@davemloft.net; netdev@vger.kernel.org;
> dl-linux-imx [ref]
> Subject: Re: [PATCH V1 net-next 0/3] net: stmmac: implement clocks
> 
> 
> 
> On 2/23/2021 6:47 PM, Joakim Zhang wrote:
> >
> >> -----Original Message-----
> >> From: Jakub Kicinski <kuba@kernel.org>
> >> Sent: 2021年2月24日 10:35
> >> To: Joakim Zhang <redacted>
> >> Cc: <redacted>; <redacted>;
> >> joabreu@synopsys.com; davem@davemloft.net; netdev@vger.kernel.org;
> >> dl-linux-imx [ref]
> >> Subject: Re: [PATCH V1 net-next 0/3] net: stmmac: implement clocks
> >>
> >> On Wed, 24 Feb 2021 02:13:05 +0000 Joakim Zhang wrote:
> >>>>> The aim is to enable clocks when it needs, others keep clocks disabled.
> >>>>
> >>>> Understood. Please double check ethtool callbacks work fine. People
> >>>> often forget about those when disabling clocks in .close.
> >>>
> >>> Hi Jakub,
> >>>
> >>> If NIC is open then clocks are always enabled, so all ethtool
> >>> callbacks should be okay.
> >>>
> >>> Could you point me which ethtool callbacks could be invoked when NIC
> >>> is closed? I'm not very familiar with ethtool use case. Thanks.
> >>
> >> Well, all of them - ethtool does not check if the device is open.
> >> User can access and configure the device when it's closed.
> >> Often the callbacks access only driver data, but it's implementation
> >> specific so you'll need to validate the callbacks stmmac implements.
> >
> > Thanks Jakub, I will check these callbacks.
> 
> You can implement ethtool_ops::begin and ethtool_ops::complete where you
> would enable the clock, and respectively disable it just for the time of the
> operation. The ethtool framework guarantees that begin is called at the
> beginning and complete at the end. You can also make sure that if the interface
> is disabled you only return a cached copy of the settings/MIB counters (they
> are not updating since the HW is disabled) and conversely only store
> parameters in a cached structure and apply those when the network device
> gets opened again. Either way would work.

Hi Florian,

Thanks for you hint. Yes, I noticed stmmac driver has implemented ethtool_ops::begin, which let ethtool only can be used when interface is enabled. Thanks a lot.

Best Regards,
Joakim Zhang
> --
> Florian
```