# \[PATCH v2 net 3/5\] sunvnet: use icmp\_ndo\_send helper

- From: Jason A. Donenfeld \<Jason@zx2c4.com\>
- Date: 2020-02-10 14:15:24 
- List: netdev
- Page: https://ratatoskr.run/netdev/2020/02/11159819
- Thread: https://ratatoskr.run/netdev/2020/02/11159816/t.md

```text
Because sunvnet is calling icmp from network device context, it should use
the ndo helper so that the rate limiting applies correctly. While we're
at it, doing the additional route lookup before calling icmp_ndo_send is
superfluous, since this is the job of the icmp code in the first place.

Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
Cc: Shannon Nelson <redacted>
---
 drivers/net/ethernet/sun/sunvnet_common.c | 23 ++++-------------------
 1 file changed, 4 insertions(+), 19 deletions(-)

diff --git a/drivers/net/ethernet/sun/sunvnet_common.c b/drivers/net/ethernet/sun/sunvnet_common.c
index c23ce838ff63..8dc6c9ff22e1 100644
--- a/drivers/net/ethernet/sun/sunvnet_common.c
+++ b/drivers/net/ethernet/sun/sunvnet_common.c
@@ -1350,27 +1350,12 @@ sunvnet_start_xmit_common(struct sk_buff *skb, struct net_device *dev,
 		if (vio_version_after_eq(&port->vio, 1, 3))
 			localmtu -= VLAN_HLEN;
 
-		if (skb->protocol == htons(ETH_P_IP)) {
-			struct flowi4 fl4;
-			struct rtable *rt = NULL;
-
-			memset(&fl4, 0, sizeof(fl4));
-			fl4.flowi4_oif = dev->ifindex;
-			fl4.flowi4_tos = RT_TOS(ip_hdr(skb)->tos);
-			fl4.daddr = ip_hdr(skb)->daddr;
-			fl4.saddr = ip_hdr(skb)->saddr;
-
-			rt = ip_route_output_key(dev_net(dev), &fl4);
-			if (!IS_ERR(rt)) {
-				skb_dst_set(skb, &rt->dst);
-				icmp_send(skb, ICMP_DEST_UNREACH,
-					  ICMP_FRAG_NEEDED,
-					  htonl(localmtu));
-			}
-		}
+		if (skb->protocol == htons(ETH_P_IP))
+			icmp_ndo_send(skb, ICMP_DEST_UNREACH, ICMP_FRAG_NEEDED,
+				      htonl(localmtu));
 #if IS_ENABLED(CONFIG_IPV6)
 		else if (skb->protocol == htons(ETH_P_IPV6))
-			icmpv6_send(skb, ICMPV6_PKT_TOOBIG, 0, localmtu);
+			icmpv6_ndo_send(skb, ICMPV6_PKT_TOOBIG, 0, localmtu);
 #endif
 		goto out_dropped;
 	}
-- 
2.25.0

```
