# Re: \[PATCH v5 net-next 06/12\] net: ethernet: ti: introduce cpsw switchdev based driver part 1 - dual-emac

- From: Grygorii Strashko \<grygorii.strashko@ti.com\>
- Date: 2019-11-01 20:35:18 
- List: netdev
- Page: https://ratatoskr.run/netdev/2019/11/5762826
- Thread: https://ratatoskr.run/netdev/2019/10/5754706/t.md

```text


On 29/10/2019 14:32, Andrew Lunn wrote:
>> +static int cpsw_probe(struct platform_device *pdev)
>> +{
>> +	const struct soc_device_attribute *soc;
>> +	struct device *dev = &pdev->dev;
>> +	struct resource *ss_res;
>> +	struct cpsw_common *cpsw;
>> +	struct gpio_descs *mode;
>> +	void __iomem *ss_regs;
>> +	int ret = 0, ch;
>> +	struct clk *clk;
>> +	int irq;
>> +
>
> ...
>
>> +
>> +	/* setup netdevs */
>> +	ret = cpsw_create_ports(cpsw);
>> +	if (ret)
>> +		goto clean_unregister_netdev;
>
> At this point, the slave ports go live. If the kernel is configured
> with NFS root etc, it will start using the interfaces.
>
> +
>> +	/* Grab RX and TX IRQs. Note that we also have RX_THRESHOLD and
>> +	 * MISC IRQs which are always kept disabled with this driver so
>> +	 * we will not request them.
>> +	 *
>> +	 * If anyone wants to implement support for those, make sure to
>> +	 * first request and append them to irqs_table array.
>> +	 */
>> +
>> +	ret = devm_request_irq(dev, cpsw->irqs_table[0], cpsw_rx_interrupt,
>> +			       0, dev_name(dev), cpsw);
>> +	if (ret < 0) {
>> +		dev_err(dev, "error attaching irq (%d)\n", ret);
>> +		goto clean_unregister_netdev;
>> +	}
>> +
>> +	ret = devm_request_irq(dev, cpsw->irqs_table[1], cpsw_tx_interrupt,
>> +			       0, dev_name(dev), cpsw);
>> +	if (ret < 0) {
>> +		dev_err(dev, "error attaching irq (%d)\n", ret);
>> +		goto clean_unregister_netdev;
>> +	}
>
> Are there any race conditions if the network starts using the devices
> before interrupts are requested? To be safe, maybe this should be done
> before the slaves are created?

Usually during boot - there is no parallel probing (as opposite to modules loading by
udev, for example). Also, there is barrier init call deferred_probe_initcall() to ensure all
drivers probed before going to mount rootfs.

So, i do not think this could cause any issue - max few packets will be delayed
until kernel will switch back here, but the chances that ndo_open will be finished before probe ->0.

-- 
Best regards,
grygorii
```
