[PATCH RFC v4 07/10] dt-bindings: net: add binding for QCA7000 UART
From: Stefan Wahren <hidden>
Date: 2017-03-27 13:41:51
Also in:
linux-devicetree, linux-serial, lkml
Subsystem:
networking drivers, open firmware and flattened device tree bindings, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
This is the serdev binding for the QCA7000 UART driver (Ethernet over UART). Signed-off-by: Stefan Wahren <redacted> --- According to this binding are still some questions: Where should be the optional hardware flow control defined (at master or slave side)? Is it okay to have two bindings (qca-qca7000-spi and qca-qca7000-uart) or should they be merged? .../devicetree/bindings/net/qca-qca7000-uart.txt | 31 ++++++++++++++++++++++ 1 file changed, 31 insertions(+) create mode 100644 Documentation/devicetree/bindings/net/qca-qca7000-uart.txt
diff --git a/Documentation/devicetree/bindings/net/qca-qca7000-uart.txt b/Documentation/devicetree/bindings/net/qca-qca7000-uart.txt
new file mode 100644
index 0000000..f2e0450
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/qca-qca7000-uart.txt@@ -0,0 +1,31 @@ +* Qualcomm QCA7000 (Ethernet over UART protocol) + +Note: This binding applies in case the QCA7000 is configured as a +UART slave device. It is possible to preconfigure the UART settings +of the QCA7000 firmware, which can't be changed during runtime. + +Required properties: +- compatible : Should be "qca,qca7000-uart" + +Optional properties: +- local-mac-address : 6 bytes, Specifies MAC address +- current-speed : Specifies the serial device speed in + bits per second (default = 115200), which is + predefined by the QCA7000 firmware configuration + +Example: + +/* Freescale i.MX28 UART */ +auart0: serial@8006a000 { + compatible = "fsl,imx28-auart", "fsl,imx23-auart"; + reg = <0x8006a000 0x2000>; + pinctrl-names = "default"; + pinctrl-0 = <&auart0_2pins_a>; + status = "okay"; + + qca7000: ethernet { + compatible = "qca,qca7000-uart"; + local-mac-address = [ A0 B0 C0 D0 E0 F0 ]; + current-speed = <38400>; + }; +};
--
2.1.4