[PATCH] Adding Reset resume support for CDC-EEM driver.

Pre-Condition
At the time of reset resume of a USB device, both self and bus powered 
devices might go to a low power state or power off state depending on 
the acceptable suspend time power of the system.    
In case the device experiences a power glitch or completely powers off 
during suspend-resume, the device will lose its internal state and 
hence it'll again need a set interface from class driver on reset resume 
operation.

Issue 
So far our experiments were based on a USB gadget working on cdc_eem 
protocol. 
We have seen that device is unable to continue the packet transfer on 
bulk endpoints after the reset resume operation.

Solution
We have added a .reset_resume function for cdc_eem protocol which sends a
set interface command on the Control endpoint. And calls the existing 
usbnet_resume thereafter


Signed-off-by: Vikas Bansal <redacted>
Signed-off-by: Sumit Batra <redacted>

diff --git a/drivers/net/usb/cdc_eem.c b/drivers/net/usb/cdc_eem.c
index f7180f8..1f6f7ea 100644
--- a/drivers/net/usb/cdc_eem.c
+++ b/drivers/net/usb/cdc_eem.c

@@ -342,6 +342,19 @@ next:
 	return 1;
 }
 
+static int cdc_eem_resume(struct usb_interface *intf)
+{
+	int ret = 0;
+	struct usbnet *dev = usb_get_intfdata(intf);
+
+	ret = usbnet_get_endpoints(dev, intf);
+	if (ret < 0)
+		goto err;
+	ret = usbnet_resume(intf);
+err:
+	return ret;
+}
+
 static const struct driver_info eem_info = {
 	.description =	"CDC EEM Device",
 	.flags =	FLAG_ETHER | FLAG_POINTTOPOINT,

@@ -371,6 +384,7 @@ static struct usb_driver eem_driver = {
 	.disconnect =	usbnet_disconnect,
 	.suspend =	usbnet_suspend,
 	.resume =	usbnet_resume,
+	.reset_resume =	cdc_eem_resume,
 	.disable_hub_initiated_lpm = 1,
 };