[PATCH net-next 07/10] tg3: Remove unused link config code
From: Matt Carlson <hidden>
Date: 2012-02-14 01:21:09
Subsystem:
broadcom tg3 gigabit ethernet driver, networking drivers, the rest · Maintainers:
Pavan Chebbi, Michael Chan, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
When tg3 devices are shutdown, the driver uses the TG3_PHYFLG_IS_LOW_POWER flag to enable a static phy configuration. Any attempt to use the link configuration variables is dead code. This patch removes such code. Signed-off-by: Matt Carlson <redacted> Reviewed-by: Michael Chan <mchan@broadcom.com> --- drivers/net/ethernet/broadcom/tg3.c | 6 +----- 1 files changed, 1 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/broadcom/tg3.c b/drivers/net/ethernet/broadcom/tg3.c
index 27cf74c..610997c 100644
--- a/drivers/net/ethernet/broadcom/tg3.c
+++ b/drivers/net/ethernet/broadcom/tg3.c@@ -3607,12 +3607,8 @@ static int tg3_power_down_prepare(struct tg3 *tp) tp->link_config.orig_autoneg = tp->link_config.autoneg; } - if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES)) { - tp->link_config.speed = SPEED_10; - tp->link_config.duplex = DUPLEX_HALF; - tp->link_config.autoneg = AUTONEG_ENABLE; + if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES)) tg3_setup_phy(tp, 0); - } } if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5906) {
--
1.7.3.4