With the 2.6.29-rc7 kernel I'm unable to 'ifup' eth0 on my ARM-based
Thecus n2100 NAS box, which has an RTL8169 NIC (10ec:8169 (rev 10)).
A diff of the kernel logs from 2.6.29-rc6 and -rc7 shows that -rc7
first mangles and then zaps the MAC addresses:
--- dmesg-2.6.29-rc6 2009-03-09 20:27:49.000000000 +0100
+++ dmesg-2.6.29-rc7 2009-03-09 20:25:54.000000000 +0100
@@ -145,11 +145,13 @@
r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
r8169 0000:00:01.0: enabling Mem-Wr-Inval
r8169 0000:00:01.0: no PCI Express capability
-eth0: RTL8169sb/8110sb at 0xe080c200, 00:14:fd:30:11:78, XID 10000000 IRQ 27
+r8169 0000:00:01.0: MAC address found in EEPROM: 00:14:fd:10:00:00
+eth0: RTL8169sb/8110sb at 0xe080c200, 00:00:00:00:00:00, XID 10000000 IRQ 27
r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
r8169 0000:00:02.0: enabling Mem-Wr-Inval
r8169 0000:00:02.0: no PCI Express capability
-eth1: RTL8169sb/8110sb at 0xe0810300, 00:14:fd:30:11:79, XID 10000000 IRQ 30
+r8169 0000:00:02.0: MAC address found in EEPROM: 00:14:fd:10:00:00
+eth1: RTL8169sb/8110sb at 0xe0810300, 00:00:00:00:00:00, XID 10000000 IRQ 30
Driver 'sd' needs updating - please use bus_type methods
sata_sil 0000:00:03.0: version 2.4
sata_sil 0000:00:03.0: Applying R_ERR on DMA activate FIS errata fix
@@ -242,6 +244,4 @@
EXT3 FS on sda5, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Adding 2008116k swap on /dev/sda3. Priority:-1 extents:1 across:2008116k
-r8169: eth0: link up
-r8169: eth0: link up
warning: `dbus-daemon' uses 32-bit capabilities (legacy support in use)
Reverting 6709fe9a27e43a4931938fe0d7f2cc5edef31386
"r8169: read MAC address from EEPROM on init (2nd attempt)"
fixes the problem on this machine.
/Mikael
Mikael Pettersson [off-list ref] :
With the 2.6.29-rc7 kernel I'm unable to 'ifup' eth0 on my ARM-based
Thecus n2100 NAS box, which has an RTL8169 NIC (10ec:8169 (rev 10)).
A diff of the kernel logs from 2.6.29-rc6 and -rc7 shows that -rc7
first mangles and then zaps the MAC addresses:
Can you apply the attached patch and see if it fixes any of these
problems ?
Tim, could you give it a try too ? It applies with "patch -p1" from
the kernel tree directory.
--
Ueimor
On Fri, Mar 13, 2009 at 4:15 PM, Francois Romieu [off-list ref] wrote:
Mikael Pettersson [off-list ref] :
quoted
With the 2.6.29-rc7 kernel I'm unable to 'ifup' eth0 on my ARM-based
Thecus n2100 NAS box, which has an RTL8169 NIC (10ec:8169 (rev 10)).
A diff of the kernel logs from 2.6.29-rc6 and -rc7 shows that -rc7
first mangles and then zaps the MAC addresses:
Can you apply the attached patch and see if it fixes any of these
problems ?
Tim, could you give it a try too ? It applies with "patch -p1" from
the kernel tree directory.
--
Ueimor
No luck:
B-25-1NOC-CFG-1:~# modprobe -if r8169
[ 120.938729] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
[ 120.945018] r8169 0000:00:09.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
[ 120.953409] r8169 0000:00:09.0: no PCI Express capability
[ 120.960359] r8169 0000:00:09.0: MAC address found in EEPROM:
00:30:18:ab:f0:34
[ 120.978441] eth1: RTL8169sc/8110sc at 0xf8154000,
00:00:00:00:f0:34, XID 18000000 IRQ 18
[ 120.988468] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
[ 120.994119] r8169 0000:00:0b.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19
[ 121.001139] r8169 0000:00:0b.0: no PCI Express capability
[ 121.006922] r8169 0000:00:0b.0: MAC address found in EEPROM:
00:30:18:ab:f0:35
[ 121.063615] eth2: RTL8169sc/8110sc at 0xf801e000,
00:00:00:00:f0:35, XID 18000000 IRQ 19
[ 121.072495] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
[ 121.078188] r8169 0000:00:0c.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 121.085239] r8169 0000:00:0c.0: no PCI Express capability
[ 121.091025] r8169 0000:00:0c.0: MAC address found in EEPROM:
00:30:18:ab:f0:36
[ 121.147502] eth3: RTL8169sc/8110sc at 0xf8022000,
00:00:00:00:f0:36, XID 18000000 IRQ 16
Tim:>