3c59x.c patch to 2.6.18 fixing Wake on Lan (WOL)

The 3c59x.c in kernel 2.6.18 (and as I see later ones too) attempts
to enable PME from the D0 state. The PME config space on Dell Optiplexs
for this chip has a zero in the capabilities as it doesn't 'wake from d0'.

So the pci_wake call fails, its result is not tested, so no error is reported.

The routine changes the wake request from 0 to D3_hot.  This fix
causes wake on lan (WOL) to work properly on older Dell Optiplex models.

Harry Coin
Bettendorf, Iowa

--- drivers-orig/3c59x.c        2007-01-15 00:03:52.000000000 -0600
+++ drivers-fixed/3c59x.c       2007-01-15 00:46:37.000000000 -0600

@@ -3090,8 +3090,8 @@
  /* Set Wake-On-LAN mode and put the board into D3 (power-down) state. */
  static void acpi_set_WOL(struct net_device *dev)
  {
-       struct vortex_private *vp = netdev_priv(dev);
-       void __iomem *ioaddr = vp->ioaddr;
+  struct vortex_private *vp = netdev_priv(dev);
+  void __iomem *ioaddr = vp->ioaddr;

         if (vp->enable_wol) {
                 /* Power up on: 1==Downloaded Filter, 2==Magic Packets, 

4==Link Status. */

@@ -3101,7 +3101,7 @@
                 iowrite16(SetRxFilter|RxStation|RxMulticast|RxBroadcast, 

ioaddr + EL3_CMD);
                 iowrite16(RxEnable, ioaddr + EL3_CMD);

-               pci_enable_wake(VORTEX_PCI(vp), 0, 1);
+               pci_enable_wake(VORTEX_PCI(vp),PCI_D3hot,1);

                 /* Change the power state to D3; RxEnable doesn't take 
effect. */
                 pci_set_power_state(VORTEX_PCI(vp), PCI_D3hot);