Subject: e1000: workaround for the ESB2 NIC RX unit issue
From: Jesse Brandeburg <redacted>

In rare occasions, ESB2 systems would end up started without the RX
unit being turned on. Add a check that runs post-init to work around this
issue.

Signed-off-by: Jesse Brandeburg <redacted>
Signed-off-by: Auke Kok <redacted>
Signed-off-by: Arjan van de Ven <redacted>
---

 drivers/net/e1000/e1000_main.c |    7 +++++++
 1 file changed, 7 insertions(+)

Index: linux-2.6/drivers/net/e1000/e1000_main.c
===================================================================

--- linux-2.6.orig/drivers/net/e1000/e1000_main.c
+++ linux-2.6/drivers/net/e1000/e1000_main.c

@@ -2579,6 +2579,13 @@ e1000_watchdog(unsigned long data)
 			netif_wake_queue(netdev);
 			mod_timer(&adapter->phy_info_timer, jiffies + 2 * HZ);
 			adapter->smartspeed = 0;
+		} else {
+			/* make sure the receive unit is started */
+			if (adapter->hw.mac_type == e1000_80003es2lan) {
+				struct e1000_hw *hw = &adapter->hw;
+				uint32_t rctl = E1000_READ_REG(hw, RCTL);
+				E1000_WRITE_REG(hw, RCTL, rctl | E1000_RCTL_EN);
+			}