Re: [RFT] New syskonnect gigabit ether driver (skge)

Here is my rewrite of the SysKonnect Gigabit Ether driver.  Gave up on
the existing sk98lin driver because it bloated and limited by the requirement
to be portable.  This version is still very experimental and has only been
run for several days on my LinkSys card (single port Yukon).
Please test on other hardware and let me know what you find out.

I had no problem with it with the following card (3Com) (not tested in
GigaEthernet mode):
(kernel 2.6.11-rc1-mm1)


0000:00:09.0 Ethernet controller: 3Com Corporation 3c940
10/100/1000Base-T [Marvell] (rev 12)
        Subsystem: ASUSTeK Computer Inc. P4P800 Mainboard
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium

TAbort- <TAbort- <MAbort- >SERR- <PERR-

        Latency: 32 (5750ns min, 7750ns max), cache line size 08
        Interrupt: pin A routed to IRQ 177
        Region 0: Memory at d6800000 (32-bit, non-prefetchable)
        Region 1: I/O ports at b800 [size=256]
        Capabilities: [48] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=1 PME-
        Capabilities: [50] Vital Product Data