FW: FSL DMA engine transfer to PCI memory

memcpy_toio() works fine, the data is written correctly. After
DMA, the correct data appears at offsets 0xC, 0x1C, 0x2C, etc.
of the destination buffer. I have 12 bytes of junk, 4 bytes of
correct data, then again 12 bytes of junk and so on.

Does your Avalon MM slave decode the 4 byte enables?
The slave always sees 2 Avalon MM writes, one of which
will have no byte enables asserted.

(Actually it is a 64bit Avalon transfer - and a bus width adapter
gets inserted for you.)

Internal M9K memory blocks get this right...

	David