[PATCH] lite5200: fix ethernet phy address
From: Dmitry Eremin-Solenikov <hidden>
Date: 2010-06-10 07:11:15
Subsystem:
linux for powerpc (32-bit and 64-bit), the rest · Maintainers:
Madhavan Srinivasan, Linus Torvalds
According to my schematics, on Lite5200 board ethernet phy uses address 0 (all ADDR lines are pulled down). With this change I can talk to onboard phy (LXT971) and correctly use autonegotiation. Signed-off-by: Dmitry Eremin-Solenikov <redacted> Cc: René Bürgel <redacted> Cc: Paul Mackerras <redacted> Cc: Grant Likely <redacted> Cc: Yogesh Chaudhari <redacted> --- arch/powerpc/boot/dts/lite5200.dts | 25 +++++++++++++++++++++++-- 1 files changed, 23 insertions(+), 2 deletions(-)
diff --git a/arch/powerpc/boot/dts/lite5200.dts b/arch/powerpc/boot/dts/lite5200.dts
index 82ff2b1..3532e6f 100644
--- a/arch/powerpc/boot/dts/lite5200.dts
+++ b/arch/powerpc/boot/dts/lite5200.dts@@ -230,8 +230,8 @@ reg = <0x3000 0x400>; // fec range, since we need to setup fec interrupts interrupts = <2 5 0>; // these are for "mii command finished", not link changes & co. - phy0: ethernet-phy@1 { - reg = <1>; + phy0: ethernet-phy@0 { + reg = <0>; }; };
@@ -281,4 +281,25 @@ 0x02000000 0 0xa0000000 0xa0000000 0 0x10000000 0x01000000 0 0x00000000 0xb0000000 0 0x01000000>; }; + + /* + localbus { + compatible = "fsl,mpc5200b-lpb","fsl,mpc5200-lpb","simple-bus"; + + #address-cells = <2>; + #size-cells = <1>; + + ranges = <0 0 0xff000000 0x01000000>; + + flash@0,0 { + compatible = "cfi-flash"; + reg = <0 0x01000000 0x00800000>; + bank-width = <1>; + #size-cells = <1>; + #address-cells = <1>; + + }; + }; +*/ + };
--
1.7.1