Dear all
I want to build a complete cross-compiling
toolchains for PowerPC, the kernel I want to build is linux-2.4.25, the
host is FC4's PC, and I also want to use glibc-2.3.6, so with all
above, which gcc, glibc,binutils should I use? And what is the step
should I do?
Thank you all and best regards,
W.Target
Jan-8-2007
-------------------------------------------------------------------
惠普商用台式机dc5750,高性能，低功耗！( http://ad4.sina.com.cn/sina/limeng3/mail_zhuiyu/2006/mail_zhuiyu_20061225.html )
===================================================================
注册新浪2G免费邮箱（ http://mail.sina.com.cn/chooseMode.html ）
On Mon, Jan 08, 2007 at 10:06:24AM +0800, onetarget@sina.com wrote:
Dear all
I want to build a complete cross-compiling
toolchains for PowerPC, the kernel I want to build is linux-2.4.25, the
host is FC4's PC, and I also want to use glibc-2.3.6, so with all
above, which gcc, glibc,binutils should I use? And what is the step
should I do?
Thank you all and best regards,
W.Target
Jan-8-2007
Haven't played with any of your specific requirements as noted above; however in the past, I've had good luck using Dan Kegel's crosstool software
www.kegel.com/crosstool
It does require a bit of trial and error to get right.
Kelsey
We use uclibc instead glibc, it is smaller.
We use buildroot to build the cross-toolchain
http://buildroot.uclibc.org/
and the following versions of binutils, gcc etc.:
Denx linux kernel 2.4.25
u-boot 1.1.6
binutils 2.14.90.0.8
gcc 3.3.6
linux-libc-headers 2.4.29
uClibc 0.9.27
gdb 6.3
I hope this helps.
Kelsey Dawes wrote:
On Mon, Jan 08, 2007 at 10:06:24AM +0800, onetarget@sina.com wrote:
Dear all
I want to build a complete cross-compiling
toolchains for PowerPC, the kernel I want to build is linux-2.4.25, the
host is FC4's PC, and I also want to use glibc-2.3.6, so with all
above, which gcc, glibc,binutils should I use? And what is the step
should I do?
Thank you all and best regards,
W.Target
Jan-8-2007
Haven't played with any of your specific requirements as noted above; however in the past, I've had good luck using Dan Kegel's crosstool software
www.kegel.com/crosstool
It does require a bit of trial and error to get right.
Kelsey
_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded