Re: Has anyone 2.6 kernel with Xenomai and MPC5200 Lite running?

In message [off-list ref] you wrote:

quoted

Then just check out the 2.6.18 version of the tree.  This  is  a  git
repo, so seeking to any version you like is a matter of seconds.

hm, I did it but was not successfully. What I did was:

...

git checkout -b private2.6.18 v2.6.18

This will give you the  exact  2.6.18  kernel.org  tree  without  any
extensions  / modifications. It has even less support for the MPC5200
than our tree, wher eit is unsupported.

Now I had kernel 2.6.18 but without network :(

ACK. The kernel.org tree does not include Sylvain's patches.

ok, that is clear but if the kernel boots fine on the board with
network and I am able to patch it with Xenomai I can live with it.

You mean, you don't care about reliability?  Umm...  then  you  don't
need Xenomai, either.

Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
"In matrimony, to hesitate is sometimes to be saved."        - Butler

Hello Wolfgang,

* Wolfgang Denk [off-list ref] [05-11-06 16:48]:

This will give you the  exact  2.6.18  kernel.org  tree  without  any
extensions  / modifications. It has even less support for the MPC5200
than our tree, wher eit is unsupported.

how can I checkout kernel 2.6.18 with denx improvements?

You mean, you don't care about reliability?  Umm...  then  you  don't
need Xenomai, either.

I need the system only for development, the targetsystem will run on
another board :)


Best regards,
Matthias

-- 

"Programming today is a race between software engineers striving to
build bigger and better idiot-proof programs, and the universe trying to
produce bigger and better idiots. So far, the universe is winning." --
Rich Cook