RE: MPC85xx PCI transfer disconnect

More information...

quoted

Did you enable Memory Read Multiple command of your PCI master?

=20
Thanks for the clue.  I'm trying to figure out how to do this.  The

PCI

master is a Tundra TSI148 VME-PCI bridge.  The documentation says it
supports the PCI read multiple cycle, but so far I haven't found a
register to specifically configure it.  I'll check the C/BE lines to

see

if a PCI read multiple cycle is being issued.
=20

After grepping through the Tundra documentation more closely, I found
this tidbit:

"Memory read multiple: The memory read multiple command is used when the
requested byte count is greater than 32 bytes."

I have confirmed that 64 bytes are being transferred before the

MPC85xx

disconnects the transfer.  If the PCI master initiates a 32 byte or 64
byte read, the MPC85xx does not disconnect the transfer.
=20

After scaning more logic analyzer captures, I noticed that occasionally
the MPC85xx inserts additional wait states (by deasserting TRDY#) after
only 32 bytes have been transferred.  So it definitely appears that (the
way I have things configured now) there's a 20-80ns delay after 1 cache
line is read, and the MPC85xx disconnects transfers that are larger than
2 cache lines.

Tim