RE: Linux on PPC

-----Original Message-----
From: linuxppc-embedded-bounces+sstrublic=3Dhypercom.com@ozlabs.org
[mailto:linuxppc-embedded-bounces+sstrublic=3Dhypercom.com@ozlabs.org]

On

Behalf Of David Hawkins
Sent: Friday, March 03, 2006 1:07 PM
To: Rune Torgersen
Cc: linuxppc-embedded@ozlabs.org
Subject: Re: Linux on PPC
=20
=20

quoted

quoted

Right, thats I made sure to say; Physical Memory Map.

For example, on the Artesyn manual on their PrPMC they give a
physical memory map, and in the Yosemite board, there is a
physical memory map. I know many of the memory areas can be
redefined in hardware to have a different memory location, but
its still a physical address.

Still not right. Even the physical memory is software settable. What
matters is what chip-select things are hooked up to, and then map

those

quoted

chip selects correctly (size, base address, access with and so on)

=20
Hi Rune,
=20
Thanks for responding.
=20
Thats what I meant with 'redefined in hardware'. But yes, redefined
up to the limit of the wiring on the board of course (chip-selects
and bus widths). That's where having the board schematic is
invaluable.
=20
But ok, I'm pretty sure I get the point, and hopefully the
original poster understands a bit more too.
=20
Given a board that you expect to run Linux on, I would imagine
you would select hardware settings consistent with making
Linux happy, i.e., defining 'in software' (the bootloader)
the physical address map (eg. like the Embedded Planet reference
manual for the 440EP Yosemite board), and then setup U-Boot and
Linux to program the TLBs to translate to those same addresses.
=20
When looking at the Yosemite board, I booted U-Boot and compared
device dcr settings to the recommended ones in the EP manual. Then
when I booted Linux, I took a look and found that on the whole, Linux
didn't touch too much of the things setup by U-Boot, i.e., the
responsibility for setting up the Linux environment was mainly
the job of the bootloader.
=20
So, if I had a board with a custom bootloader, I would be
concerned that the bootloader might not know enough about
Linux, to setup the hardware correctly.

The boot loader should, ideally, NOT know anything about Linux except
for knowing that since a Linux is being loaded, it requires some
information at boot time, and the format in which to provide said
information.

Steve

=20
Does that sound right?
=20
Dave
=20
=20
=20
=20
=20
_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded