RE: MPC885ADS and 2.6.13-rc5 - nogo ?

Hello Vitaly,=20

From: Vitaly Bordug [mailto:vbordug@ru.mvista.com]=20

Mentioned support should work `out-of-the box`.
Make sure you have console=3DttyCPM0,115200 (or whatever baudrate you=20
have) within bootargs in the U-Boot environment. U-Boot modification

is=20

needed only if you wish to have both FEC MAC addresses configured via=20
U-Boot env as well. Also only the related defconfig should be used.

I have the bootargs, but still nogo - even with the mpc885ads_defconfig.

Besides, in the mpc885ads_defconfig CONFIG_SCC3_ENET is set but in the
patch
description it reads as if only SCC1 is supported...

 Best Regards,

  Peter

Schaefer-Hutter, Peter wrote:

Hello Vitaly, 

 

quoted

From: Vitaly Bordug [mailto:vbordug@ru.mvista.com] 

Mentioned support should work `out-of-the box`.
Make sure you have console=ttyCPM0,115200 (or whatever baudrate you 
have) within bootargs in the U-Boot environment. U-Boot modification
   

is 
 

quoted

needed only if you wish to have both FEC MAC addresses configured via 
U-Boot env as well. Also only the related defconfig should be used.
   

I have the bootargs, but still nogo - even with the mpc885ads_defconfig.

Besides, in the mpc885ads_defconfig CONFIG_SCC3_ENET is set but in the
patch
description it reads as if only SCC1 is supported...

Best Regards,

 Peter

 

The board does not hang - there's somithing with console since you don't 
see anything.  Try to change BCSR_ADDR from 0xf4500000 to 0xf80...0 - 
the newer version of the boards may have this changed.


-- 
Sincerely, 
Vitaly