Hello,
i have a custom PPC 440 GX board which should run linux 2.6.11.6 kernel. I
initialized the board with u-boot getting boot console on UART1 to start the
kernel with bootm command.
Hardware details:
PPC 440 GX CPU
2 * 256 MB RAM
2 * 8 MB Flash
EM Marvin RTC V3020 (seems not supported by linux?)
Now i want to configure Linux to match my custom board. I ported my board
based on ocotea board configuration files and excluded all the stuff i don´t
need. My kernel seems to load but get stuck on calibrating delay loop and
loops between update_proces_times and __delay (at address 0xC0003400) until
it reboots. Seems like i didn´t match the BogoMips calculation. Actually i
don´t use the RTC (i comment out all TODC functions). I think this cause the
problem. So what i have to do to boot without RTC or has someone my RTC
running with linux?
Thanks for advice,
David
On Thu, Jun 30, 2005 at 01:26:52PM +0200, David Grab wrote:
Hello,
i have a custom PPC 440 GX board which should run linux 2.6.11.6 kernel. I
initialized the board with u-boot getting boot console on UART1 to start the
kernel with bootm command.
Hardware details:
PPC 440 GX CPU
2 * 256 MB RAM
2 * 8 MB Flash
EM Marvin RTC V3020 (seems not supported by linux?)
Now i want to configure Linux to match my custom board. I ported my board
based on ocotea board configuration files and excluded all the stuff i don?t
need. My kernel seems to load but get stuck on calibrating delay loop and
loops between update_proces_times and __delay (at address 0xC0003400) until
it reboots. Seems like i didn?t match the BogoMips calculation. Actually i
don?t use the RTC (i comment out all TODC functions). I think this cause the
problem. So what i have to do to boot without RTC or has someone my RTC
running with linux?
Most likely, you have incorrectly setup serial console, so you don't
see any messages. Then some other error happens and kernel panics,
it'll wait for 3min and then reboots. Try accessing printk buffer
through BDI or other hw debugger.
Also, RTC isn't required for Linux ti run.
--
Eugene
David Grab wrote:
Now i want to configure Linux to match my custom board. I ported my board
based on ocotea board configuration files and excluded all the stuff i don´t
need. My kernel seems to load but get stuck on calibrating delay loop and
loops between update_proces_times and __delay (at address 0xC0003400) until
it reboots. Seems like i didn´t match the BogoMips calculation. Actually i
don´t use the RTC (i comment out all TODC functions). I think this cause the
problem. So what i have to do to boot without RTC or has someone my RTC
running with linux?
You are most likely not passing the clock speed from bootloader
correctly. You can set it forcibly in the beginning of ocotea.c, or
else fixup the structure passed between bootloader and kernel so that
both sides match. Doing the latter will fix a lot of other troubles
that you will encounter later on as well. See also:
http://www.denx.de/twiki/bin/view/DULG/LinuxHangsAfterUncompressingKernel
-R