U_BOOT console baudrate mismatch

Hi all,
 
 I am a newbie in this area and i am here hoping some
help from our friendly programmers. I am working with
PwerPc processor MPC5200 with the board that was
produced in our company. Rightnow we have U_BOOT-1.1.1
and the problem is that it doesnt print wel on the
console. I have no hands on experience in workin with
u-boot... 

the messages look very ugly like this ....


U-Boot 1.1.1 (Ju�23 2005 - 11:29:29)

CPU:   MPC5200 (JTAG ID 0001101d) at 396 .Hz
       .us 132 MH IPB 66 MHz, PCI 33 .Hz
Boardo Mitron .CT3
.F..SH:  4 M.
.In:    ser�ld FPGA binary image
Out:   serial
Err:   serial
NAND:      

---------------
Bus --> 132MH 
IPB ---> 66 MH 
PCI ---> 33 MH 
FLASH --> 4M
and so on..

 my server machine to which the board is connected has
the console with baud 38400 and i think u-boot default
baudrate is 115200 or 19200 (i am not sure)... where
should i need to change???? any sort of help or
redirections is greatly appreciated...

thanks a lot for you replies in advance


		
____________________________________________________ 
Yahoo! Sports 
Rekindle the Rivalries. Sign up for Fantasy Football 
http://football.fantasysports.yahoo.com

Hello Susheel Raj

the console with baud 38400 and i think u-boot default
baudrate is 115200 or 19200 (i am not sure)... where
should i need to change???? any sort of help or
redirections is greatly appreciated...

 
There is an environment setting baudrate you can change.
For informations read the DULG at the homepage from denx www.denx.de

regards

achim