[Fwd: [PATCH] ppc32: add Freescale MPC885ADS board support]

Forwarding to the correct address.

-------- Original Message --------
Subject: [PATCH] ppc32: add Freescale MPC885ADS board support
Date: Fri, 10 Jun 2005 21:09:28 +0400
From: Andrei Konovalov <redacted>
To: Tom Rini <redacted>
CC: linux-kernel@vger.kernel.org,   linuxppc-embedded@lists.linuxppc.org

This patch adds the Freescale MPC885ADS board to 2.6.12-rc6.
The supported devices are two SMC UARTs and 10Mbit ethernet on SCC3.

FEC is not supported as the "combined FCC/FEC ethernet driver" driver
by Pantelis Antoniou (first posted to this list on May 9; I'll
call it "fs_enet" for short) should replace the current FEC driver.

On MPC885ADS SCC ethernet PHY defaults to the full duplex mode
upon reset. SCC is set to half duplex by default. This inconsistency
is not handled by this patch for the following reasons:
- ethernet works anyway (the statistics should look terrible though)
- we are working on a patch to add SCC ehternet support to the fs_enet
    driver, and will revisit this full/half duplex issue when moving
    the board to the new ethernet driver and platform devices.

Signed-off-by: Yuri Shpilevsky <redacted>
Signed-off-by: Andrei Konovalov <redacted>