Hi All
I'm running Sylvain Munaut's version of 2.6.10-rc2 with DENX's 3.1 ELDK =
as
the cross
compile tools with nfs mounted root filesystem and I seem to have a =
probelm
when I'm=20
connected to the "icecube" development boards serial port.
I get the u-boot 1.1.3 bootrom messages from the serial port on the
"icecube" and can=20
boot the kernel using the serial port but I don't get any messages after =
the
early=20
boot message "arch: exit". It appeared to me that the board was booting =
so I
tried to=20
telnet via the network to the board and this worked fine. So the kernel =
is
running, I=20
just don't get the "normal" bootup messages from the kernel.
If I use the standard DENX 2.4.25 kernel I get all the message going to =
the
serial=20
port OK.
Any ideas of whats going on ????? Is their a problem with the console
support in=20
Sylvain's port or something in the "standard" init scripts that come =
with
DENX's ELDK=20
3.1 when used with a 2.6.xx kernel or have I missed something obvious?
Linas Petras
------------
I know not with which weapons World War III will be faught, but World =
War IV
will be faught with sticks and stones. - Albert Einstein.
Hi
Does your kernel cmdline includes the "console=ttyS0" ?
It's mandatory here while with DENX's kernel it may not be.
The initscript are not even launched at that point ...
Sylvain
Linas Petras wrote:
Hi All
I'm running Sylvain Munaut's version of 2.6.10-rc2 with DENX's 3.1 ELDK as
the cross
compile tools with nfs mounted root filesystem and I seem to have a probelm
when I'm
connected to the "icecube" development boards serial port.
I get the u-boot 1.1.3 bootrom messages from the serial port on the
"icecube" and can
boot the kernel using the serial port but I don't get any messages after the
early
boot message "arch: exit". It appeared to me that the board was booting so I
tried to
telnet via the network to the board and this worked fine. So the kernel is
running, I
just don't get the "normal" bootup messages from the kernel.
If I use the standard DENX 2.4.25 kernel I get all the message going to the
serial
port OK.
Any ideas of whats going on ????? Is their a problem with the console
support in
Sylvain's port or something in the "standard" init scripts that come with
DENX's ELDK
3.1 when used with a 2.6.xx kernel or have I missed something obvious?
Linas Petras
------------
I know not with which weapons World War III will be faught, but World War IV
will be faught with sticks and stones. - Albert Einstein.
_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded