RE: Linux 2.6-10.rc3 8xx: debugging (over-writing) content of b d_in fo structure in the kernel booting code

Sorry - no hardware instruments, support (and skills ;-) ) here ...
anything else to try software-wise (no JTAG debugging is available either) ?

-----Original Message-----
From: Mark Chambers [mailto:markc@mail.com]
Sent: Tuesday, January 18, 2005 10:23 AM
To: Povolotsky, Alexander; linuxppc-embedded@ozlabs.org
Subject: Re: Linux 2.6-10.rc3 8xx: debugging (over-writing) content of
bd_in fo structure in the kernel booting code

So what could go wrong here in terms of setting the baudrate for the

serial

uart
(which "presumably" causes printing 3 good characters and then garbage
during kernel booting) ?

If you can get your hands on an oscilloscope and look at the TxD from your
board, you can get an exact measurement of your baudrate and make sure
you are on the right track. (Baudrate = 1/shortest-high-or-low-time)

Mark Chambers