In message [off-list ref] you wrote:
And of course it should be inserted correctly - sorry if this is too
obvious!
This is not too obvious, as the card will easily fit in the opposite
orientation, too (poor design of the board, IMHO).
One card, that is known to work in this slot is the Intel eepro100 NIC.
Or the Coral-P graphics card :-)
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd@denx.de
Proboscis: The rudimentary organ of an elephant which serves him in
place of the knife-and-fork that Evolution has as yet denied him. For
purposes of humor it is popularly called a trunk. - Ambrose Bierce
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
On Monday 21 June 2004 12:53, Wolfgang Denk wrote:
In message [off-list ref] you wrote:
quoted
And of course it should be inserted correctly - sorry if this is too
obvious!
This is not too obvious, as the card will easily fit in the opposite
orientation, too (poor design of the board, IMHO).
You are right, these designs are completely crap!!!
quoted
One card, that is known to work in this slot is the Intel eepro100 NIC.
Or the Coral-P graphics card :-)
Of course, you're right again, but they're pretty expensive ;-)
Ciao,
Gerhard
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Wolfgang Denk wrote
quoted
One card, that is known to work in this slot is the Intel eepro100 NIC.
Or the Coral-P graphics card :-)
Small notice about Coral-P card. Least one that i have needs separate
-12V to connec to PCI
connector pins. There is no -12V supply on board. The Coral-P does
itself need
-12V but there is one analog mux in video output that needs -5V that is
generated from -12V.
Other possible problem is that i found with ATI Rage Mobility M1 EVA board
that it's 723 3.3V regulator needed as default +12V to operate.
I also have used sucessfulle Xilinx Spartan2 PCI EVA board and
TI1410 cardbus bridge board without problems.
It looks a like that wery ccommon problem is that many board needs some
+/-12V
event thay should not.
Kate
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/