Re: how to use the i2c in mpc5200

In message [off-list ref] you wrote:

i am using the linuxppc-2.4.25-denx and loaded
this modules

Which sort of hardware are you using? Is this by any chance an  early
IceCube board? I2C didn't work on some of these boards.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
Heavier than air flying machines are impossible.
                    -- Lord Kelvin, President, Royal Society, c. 1895

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

i dont think it is the case . I am using a lite5200 version 2.0 with 16
mg of flash
And i think the uboot uses the i2c for store some information.

Wolfgang Denk wrote:

In message [off-list ref] you wrote:

quoted

i am using the linuxppc-2.4.25-denx and loaded
this modules

Which sort of hardware are you using? Is this by any chance an  early
IceCube board? I2C didn't work on some of these boards.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
Heavier than air flying machines are impossible.
                   -- Lord Kelvin, President, Royal Society, c. 1895

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/