How to test Serial data transfer beyond 115k up to 1.5Mbps

Hi All,

I want to test my serial driver at higher speeds, How to test serial data
transfer  up to 1.5Mbps speed.
Is it zmodem protocol supports this speed?
I am able to test it (using zmodem protocol )up to 115K, beyond this I am
facing problem.

Thanks in advance

Regards,
Ashok

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

Hegde, Ashok wrote:

I want to test my serial driver at higher speeds, How to test serial
data transfer up to 1.5Mbps speed. Is it zmodem protocol supports this
speed? I am able to test it (using zmodem protocol )up to 115K, beyond
this I am facing problem.

You mentioned 115k2, probably an async port.
Do you want to run async at 1,5mbit/s?
What kind of device will that be?
I think the zmodem protocol does not mind to be used at higher rates :o)
Your problem is probably somewhere else. (drivers?)

JB

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

Dear All,

I know the board based on mpc852T supported by ELDK3.0 are AdderII and
MPC86xADS.

Could you tell me which boards based on MPC852T are supported by ELDK3.0
except AdderII and MPC86xADS?

Thanks in advance!
John

Hegde, Ashok wrote:

quoted

I want to test my serial driver at higher speeds, How to test serial
data transfer up to 1.5Mbps speed. Is it zmodem protocol supports
this speed? I am able to test it (using zmodem protocol )up to 115K,
beyond this I am facing problem.

You mentioned 115k2, probably an async port. Do you want to run async
at 1,5mbit/s? What kind of device will that be? I think the zmodem
protocol does not mind to be used at higher rates :o) Your problem is
probably somewhere else. (drivers?)

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/