mount root on the ml300 board

hi,
    I am debugging MontaVista linux pro3.0(kernel 2.4.28) on the ml300
board. I use IBM MicroDrive 1GB card to configure the FPGA and act as
root fs. But the boot stops and displays the following:
...
block: 128 slots per queue, batch=32
Partition check:
 xsysacea: xsysacea1 xsysacea2 xsysacea3
System ACE at 0xCF000000 mapped to 0xC900F000, irq=9, 1052352KB
Kernel panic: I have no root and I want to scream
 <0>Rebooting in 180 seconds..
    There are 3 partitions in the CF card. The 1st is the fat12. The 2st
is swap and the 3rd is the root. Kernel command line: console=ttyS0,9600
root=/dev/sysace3 rw
    Did someone have the problem? Any hints will be appreciable.

Thanks!

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

Make sure to enable device file system (/devfs) support during kernel
configuration.

- Peter

hyding wrote:

hi,
   I am debugging MontaVista linux pro3.0(kernel 2.4.28) on the ml300
board. I use IBM MicroDrive 1GB card to configure the FPGA and act as
root fs. But the boot stops and displays the following:
...
block: 128 slots per queue, batch=32
Partition check:
xsysacea: xsysacea1 xsysacea2 xsysacea3
System ACE at 0xCF000000 mapped to 0xC900F000, irq=9, 1052352KB
Kernel panic: I have no root and I want to scream
<0>Rebooting in 180 seconds..
   There are 3 partitions in the CF card. The 1st is the fat12. The 2st
is swap and the 3rd is the root. Kernel command line: console=ttyS0,9600
root=/dev/sysace3 rw
   Did someone have the problem? Any hints will be appreciable.

Thanks!

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/