Mark,
Can you give me some insight as to where it is located then? I do not see support for it in U-Boot nor the kernel version I mentioned (2.4.21).
Dan
-----Original Message-----
From: Mark A. Greer [mailto:mgreer@mvista.com]
Sent: Thursday, January 23, 2003 4:20 PM
To: Dan Douglass
Cc: linuxppc-embedded@lists.linuxppc.org
Subject: Re: Sandpoint X3 with MPC755
Dan Douglass wrote:
Hello,
I am looking into getting Linux up on the Sandpoint III with a MPC755. I have not seen much on the list regaurding this platform. Has anyone done this already?
Its been there for a very long time...
Mark
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Dan Douglass wrote:
Mark,
Can you give me some insight as to where it is located then? I do not see support for it in U-Boot nor the kernel version I mentioned (2.4.21).
Dan,
You must not be looking in the right place (for kernel support).
Sandpoint X3 support is in the linuxppc_2_4_devel tree. You can clone
the bk repository at bk://ppc.bkbits.net/linuxppc_2_4_devel.
As far as U-Boot, I don't use it but I thought it ran on the sandpoint
(at least, I think PPCBoot used to). DINK comes on the sandpoint & the
zImage.sandpoint produced when you build the kernel (make zImage) will
run on recent versions of that firmware.
If you need more help getting the source, try looking at
http://penguinppc.org/dev/kernel.shtml Note that there are currently a
few problems with IDE in that tree right now.
If you're looking for a truly supported version, go to
http://www.mvista.com and/or [I believe] http://www.denx.de. There are
probably others as well.
Mark
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/