Re: LXT972 FEC problem on MPC855

Shawn:

Maybe I have a contribution...

On Monday 26 August 2002 18:32, Xiaogeng (Shawn) Jin wrote:

quoted

You are passing bad/insufficient boot arguments to the Linux  kernel;
unfortunaltely you don;t show us this part of the boot messages, so I
cannot even guess what you're doing wrong.

Finally I figured out the problem and solved it. The problem is that the
kernel didn't get the LINK status correctly. The 'fep->link' was always
0 which means the link is down or autonegotiation is in progress.

In the code which defines 'phy_info_lxt971', it says that somehow LXT971
tells me that the link is down when the first read after power-up. So
you have to read MII_REG_SR to set 'fep->phy_status' accordingly. But in
my case, the read action occurred too early to wait till the link is up.
So what I did is to delay 5s before reading MII_REG_SR during opening
FEC device. I guess it takes the link a while to autonegotiate the speed.

Hmm. I suppose PHY should interrupt when link status change, and therefore
phy_status would be updated accordingly. So, maybe you have a problem with
your board's PHY interrupt signal.

Hope this helps.

-Scop.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

quoted

In the code which defines 'phy_info_lxt971', it says that somehow LXT971
tells me that the link is down when the first read after power-up. So
you have to read MII_REG_SR to set 'fep->phy_status' accordingly. But in
my case, the read action occurred too early to wait till the link is up.
So what I did is to delay 5s before reading MII_REG_SR during opening
FEC device. I guess it takes the link a while to autonegotiate the speed.

Hmm. I suppose PHY should interrupt when link status change, and therefore
phy_status would be updated accordingly. So, maybe you have a problem with
your board's PHY interrupt signal.

Yeah, I think so. So I have to check whether the PHY interrupt is
enabled or not. Thanks for your thoughts.

- Shawn.


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/