old-world boot freeze; 2.4.19-rc2

Just rsynced 2.4.19-rc2 from source.mvista.org (although official
kernel is at rc3?). Built fine, but when I try to boot it on a 9500
with a Powerlogix G3 upgrade, the last two things I see (early in the
boot) are:

setup_arch: enter
setup_arch: bootmem

And then it just locks up.

Any ideas? Last kernel I've been running on this is 2.4.18, with no problems.


Stefan Jeglinski

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

Just rsynced 2.4.19-rc2 from source.mvista.org (although official
kernel is at rc3?). Built fine, but when I try to boot it on a 9500
with a Powerlogix G3 upgrade, the last two things I see (early in the
boot) are:

setup_arch: enter
setup_arch: bootmem

And then it just locks up.

Any ideas? Last kernel I've been running on this is 2.4.18, with no problems.

I works fine on a 8500 SMP here (with no G3 upgrade though). Can you
try routing printk to the btext engine ?
(use my tree and add printkbext to the command line)
Tell me what are the last messages.

Ben.


** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/