Hello everybody,
I have 860T FADS board, and I am trying to access the (board specific)
registers BCSRs.
I have no problem accessing them in PPCBOOT, since they are accessed
through CS1, at address FF01xxxx, but I can't access them in linux for
the moment.
My first attempt was by using the /dev/mem device, but it doesn't seem
to work, the result read are not correct.
so I have to question
1) why doesn't it work, I probably don't understand how /dev/mem works
: does it map only memory and not the address space ? do I have to
register the address range or the BCSR in the kernel ?
2) what is the proper way of doing this ? writing a driver ? or using
/dev/mem properly ?
thx for your help...
Jeremy
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Hi,
If you have memory-mapped io (The (F)ADS8xx BCSR registers is a
good example) which is mapped to a certain physical address, it
is very simple to access it if the MMU is turned off.
The Linux kernel runs with the MMU on, and it needs a
virtual-to-physical
address mapping to be able to access memory-mapped io.
So, my 2.2-kernel has a file called arch/ppc/mm/init.c.
Inside that file there's a function called "ioremap()" - that is what
you are looking for.
Make sure that your Linux kernel has a virtual page for your io-area,
and access the virtual address that is returned by "ioremap()".
If you use "ioremap()" before a certain moment when the Linux kernel
starts up, you will get a 1:1 mapping between virtual and physical
addresses.
(This is true for 2.2 anyhow)
Look how the internal io block is ioremap():ped for a good example how
it is done.
Cheers /
magnus
Jeremy Rosen wrote:
Hello everybody,
I have 860T FADS board, and I am trying to access the (board specific)
registers BCSRs.
I have no problem accessing them in PPCBOOT, since they are accessed
through CS1, at address FF01xxxx, but I can't access them in linux for
the moment.
My first attempt was by using the /dev/mem device, but it doesn't seem
to work, the result read are not correct.
so I have to question
1) why doesn't it work, I probably don't understand how /dev/mem works
: does it map only memory and not the address space ? do I have to
register the address range or the BCSR in the kernel ?
2) what is the proper way of doing this ? writing a driver ? or using
/dev/mem properly ?
thx for your help...
Jeremy
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/