Re: SysVInit (RC Scripts) on HHL 2.0 (Add'n info)

Mark Hatle wrote:

quoted

James F Dougherty wrote:

quoted

I am using HHL 2.0 (2.4.2) on MPC8240 and I downloaded
the root filesystem RPM's from

ftp://ftp.mvista.com/pub/Journeyman/cd2/ppc_82xx/apps/*.rpm

Is there some bug in HHL 2.0 on ppc_82xx I don't know about?

Assuming you used the installer, only the init scripts required to boot
a minimal system (and be able to telnet in and use nfs root) are
enabled.  Anything beyond that you, the developer/user will need to
enable.  If you did not use the installer, you probably got a bunch of
messages during installation such as "Unable to enable initd service:
checkfs.sh".  These messages mean that the initdconfig program was not
able to be run for some reason or another, thus you probably don't have
ANY initscripts installed.

The initscripts are further discussed in the "Initscript Overview"
section of Chapter 7.

FYI, if you did not use the installer, and want to try to "rescue" your
installation, the following initscripts are enabled by default in the
installer.  (If I list an initscript you don't have ignore it, it isn't
part of Journeyman then.)

bootmisc.sh    	S:on
checkfs.sh     	S:on
checkroot.sh   	S:on
devpts.sh      	S:on
mountall.sh    	S:on
mountnfs.sh    	S:on
umountfs       		0:on

6:on

umountnfs.sh   		0:on

6:on

ifupdown       	S:on
networking     	S:on
inetd          				2:on	3:on	4:on	5:on
portmap        	S:on
syslog         				2:on	3:on	4:on	5:on

Yup, got it. I used initdconfig to add all of the services I wanted.
Then, I turned them on.

Works perfectly!

Many thanks again for all of your help -- and such an excellent product.

				-James


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/