Re: mesh SCSI bus locks hard on 7500 when burning a CD-R in dao mode

On Sat, Jan 27, 2001 at 04:31:15PM -0500, Daniel Eisenbud [off-list ref] wrote:

On Fri, Jan 26, 2001 at 10:32:35PM +0100, Michael Schmitz [off-list ref] wrote:

quoted

# same to a separate screen
*.info;mail.none;authpriv.none;local0.none		/dev/tty7

is what keeps a not-too-cluttered log (copy of /var/log/messages) on tty7
of our server. kern.notice to some tty would probably be enough for you.

quoted

and not to any files so syslogd won't freeze when SCSI goes?  Is there

So put just that one line redirecting log output to /dev/tty7 into
syslog.conf temporarily and kill -1 syslogd before starting the test.

I'll try this variation in a few minutes.

This worked, but I didn't get any useful log output until I started
getting error 600 from the SCSI midlevel and errors from ext2fs.  I'm
going to try again, making sure that I have dmesg set as high as
possible, and see if I can get anything else.  Otherwise, is it time to
start scattering printk()'s around the mesh driver?

-Daniel

--
Daniel E. Eisenbud
eisenbud@cs.swarthmore.edu

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

quoted

quoted

So put just that one line redirecting log output to /dev/tty7 into
syslog.conf temporarily and kill -1 syslogd before starting the test.

I'll try this variation in a few minutes.

This worked, but I didn't get any useful log output until I started
getting error 600 from the SCSI midlevel and errors from ext2fs.  I'm
going to try again, making sure that I have dmesg set as high as

Please report the precise message text.

	Michael


** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/