Re: Fwd: mesh SCSI bus locks hard on 7500 when burning a CD-R in dao mode

on Fri, Jan 26, 2001 at 12:07:24PM +0100, Benjamin Herrenschmidt [off-list ref] wrote:

quoted

I have a Powermac 7500 (with a G3 accelerator.)  I have replaced the
internal CD-ROM with a Yamaha CD-RW drive.  This sits on the mesh SCSI
bus.  I have the mesh driver configured to run at 5 megabytes/second
(since I get massive SCSI problems all over the place if I set it to
10.)  Under a variety of kernels, from 2.2.15 or so to 2.4.0 from Paul
Mackeras's tree, my SCSI setup is generally stable and I can burn CD-R
disks just fine in track-at-once mode.  However, if I try to burn a disk
in disk-at-once mode, either with cdrdao or cdrecord, the SCSI bus
appears to silently lock up hard, bringing down my whole machine.
Nothing is logged at all, as far as I can tell.  Has anyone had this
problem before?  Does anyone know of a solution?  If not, how would I go
about debugging this further?

Do you see any kind of kernel error messages on the console before it
locks up ?

Nope, nothing at all.  :-(  It just freezes.  Since the SCSI bus is
gone, any attempts to write to logs fail, as do any attempts to read
them, of course.  cdrdao gets to the "calibrating power" stage, the
light on the cd-rw drive blinks for a few seconds, and that's it.   Last
time I tried this experiment, I at least turned swap off first, and the
system survived a bit longer, but I wasn't able to find anything out.
Is there any other way to probe what's going on?  I do have a 2 gigabyte
drive that I could attach to the external SCSI bus and boot from: maybe
then I could get more info, at least, about what is going on.

-Daniel

--
Daniel E. Eisenbud
eisenbud@cs.swarthmore.edu

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

Nope, nothing at all.  :-(  It just freezes.  Since the SCSI bus is
gone, any attempts to write to logs fail, as do any attempts to read
them, of course.  cdrdao gets to the "calibrating power" stage, the
light on the cd-rw drive blinks for a few seconds, and that's it.   Last
time I tried this experiment, I at least turned swap off first, and the
system survived a bit longer, but I wasn't able to find anything out.
Is there any other way to probe what's going on?  I do have a 2 gigabyte
drive that I could attach to the external SCSI bus and boot from: maybe
then I could get more info, at least, about what is going on.

Do you get the same lockup without the G3 accelerator ?

Ben.

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/