Re: [PATCH] ath10k: fix wmm params per vdev

On 6 February 2015 at 14:41, Marek Puzyniak [off-list ref] wrote:

During wmm tests changing wmm parameters did not change anything.
This was because of mismatch in WMM params per vdev command.
WMM params per vdev uses different command structure than wmm params
per pdev command. Also txop for per vdev settings has the
same units as provided by mac80211.

Patch concerns qca6174.

Signed-off-by: Marek Puzyniak <redacted>

Kalle,

Please do not merge this patch yet. I need to clarify some side effects.
I will inform you about next steps.

Thanks,
Marek

Marek Puzyniak [off-list ref] writes:

On 6 February 2015 at 14:41, Marek Puzyniak [off-list ref] wrote:

quoted

During wmm tests changing wmm parameters did not change anything.
This was because of mismatch in WMM params per vdev command.
WMM params per vdev uses different command structure than wmm params
per pdev command. Also txop for per vdev settings has the
same units as provided by mac80211.

Patch concerns qca6174.

Signed-off-by: Marek Puzyniak <redacted>

Kalle,

Please do not merge this patch yet. I need to clarify some side effects.
I will inform you about next steps.

Ok, I have dropped the patch. Please resend if it's ok to apply.

-- 
Kalle Valo