Hello,
i need to find a solution how to enable an embedded system (TI davinci
board, dm365, arm CPU, kernel is 2.6.32.17 from the TI psp03.01.01.38
sdk).
Could someone advise me on what the most suitable solution might be? I
know i should be using hostapd, but what would be the best wireless
stick?
Until now i have tried out the D-Link DWL-G122 and Linksys WUSB54GC-EU
for the rt73usb driver is listed as supporting AP- mode, but i could
not get tham to work:
I've enabled the drivers as modules in the kernel, downloaded the
firmware and loaded it in /lib/firmware, but the sticks don't get
assigned as wireless interfaces.
I've managed to enable an AVM wireless n stick with the ar9170 driver,
but as ar9170 does not support ap mode- hostapd couldn't do anything.
I will be very thankful for any help or advice on what the best stick
for an embedded system as mine might be. Furthermore- is there any
soulution
for enabling the davinci board as an access point? i have 3 USB ports,
a serial port and jtag available.
Best Regards,
Boyan Penev
Hi,
some time back, I enabled hostapd with Edimax USB wireless card. It
runs on rt73 driver. You need to compile hostapd with libnl-2.0.
Thanks
On Mon, May 23, 2011 at 8:46 PM, Boyan Penev [off-list ref] wrote:
Hello,
i need to find a solution how to enable an embedded system (TI davinci
board, dm365, arm CPU, kernel is 2.6.32.17 from the TI psp03.01.01.38
sdk).
Could someone advise me on what the most suitable solution might be? I
know i should be using hostapd, but what would be the best wireless
stick?
Until now i have tried out the D-Link DWL-G122 and Linksys WUSB54GC-EU
for the rt73usb driver is listed as supporting AP- mode, but i could
not get tham to work:
I've enabled the drivers as modules in the kernel, downloaded the
firmware and loaded it in /lib/firmware, but the sticks don't get
assigned as wireless interfaces.
I've managed to enable an AVM wireless n stick with the ar9170 driver,
but as ar9170 does not support ap mode- hostapd couldn't do anything.
I will be very thankful for any help or advice on what the best stick
for an embedded system as mine might be. Furthermore- is there any
soulution
for enabling the davinci board as an access point? i have 3 USB ports,
a serial port and jtag available.
Best Regards,
Boyan Penev
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html