# Re: Re: \[PATCH V1\] raidd5:Only move IO\_THRESHOLD stripes from delay\_list to hold\_list once.

- From: majianpeng \<hidden\>
- Date: 2012-07-16 01:09:54 
- List: linux-raid
- Page: https://ratatoskr.run/linux-raid/2012/07/6621045
- Thread: https://ratatoskr.run/linux-raid/2012/07/6621039/t.md

```text
On 2012-07-14 07:56 Dan Williams [ref] Wrote:
>[ adding Shaohua ]
>
>On Fri, Jul 13, 2012 at 3:31 AM, majianpeng [ref] wrote:
>> To improve write perfomance by decreasing the preread stripe,only move
>> IO_THRESHOLD stripes from delay_list to hold_list once.
>>
>> Using the follow command:
>> dd if=/dev/zero of=/dev/md0 bs=2M count=52100.
>>
>> At default condition: speed is 95MB/s.
>> At the condition of preread_bypass_threshold was equal zero:speed is 105MB/s.
>> Using this patch:speed is 123MB/s.
>>
>> If preread_bypass_threshold was zero,the performance will be better,but
>> not better than this patch.
>> I think maybe two reason:
>> 1:If bio is REQ_SYNC
>> 2:In function __get_priority_stripe():
>>>> } else if (!list_empty(&conf->hold_list) &&
>>>>                 ((conf->bypass_threshold &&
>>>>                   conf->bypass_count > conf->bypass_threshold) ||
>>>>                  atomic_read(&conf->pending_full_writes) == 0)) {
>> Preread_bypass_threshold is one condition of getting stripe from
>> hold_list.So only control the number of hold_list can get better
>> performance.
>
>So this is a pretty obvious tradeoff of increased latency for improved
>throughput.  Any idea how much this change affects latency?
>Especially in the fast device case?
I did not think the latency.If it only fetch preread_bypass_threshold stripes from delay_list to 
host_list,the latency can be control by userspace.
The code like :

static void raid5_activate_delayed(struct r5conf *conf)
 {
+ int count = 0;
  if (atomic_read(&conf->preread_active_stripes) < IO_THRESHOLD) {
  while (!list_empty(&conf->delayed_list)) {
  struct list_head *l = conf->delayed_list.next;
@@ -3672,6 +3673,8 @@ static void raid5_activate_delayed(struct r5conf *conf)
  if (!test_and_set_bit(STRIPE_PREREAD_ACTIVE, &sh->state))
  atomic_inc(&conf->preread_active_stripes);
  list_add_tail(&sh->lru, &conf->hold_list);
+ if (++count >= conf->preread_active_stripes)
+ break;
  }
 


```
