# Re: Green drives and RAID arrays with partity

- From: Marcin M. Jessa \<hidden\>
- Date: 2011-09-25 14:28:16 
- List: linux-raid
- Page: https://ratatoskr.run/linux-raid/2011/09/6617461
- Thread: https://ratatoskr.run/linux-raid/2011/09/6617455/t.md

```text
On 9/25/11 1:43 PM, Stan Hoeppner wrote:

[...]

>
> When you have a problem such as yours, and you ask for help on this, or
> any other Linux kernel list, it's a really good idea to post all of the
> relevant information up front. Why? Because most often when drives drop
> out of arrays it is not because a disk failed or the disk has buggy
> firmware. It's most often because of problems elsewhere in the storage
> stack, either hardware or software.

I wasn't sure which information I should attach and I did not want to spam the list. I was hoping someone would tell me if some of the relevant information was missing so I could send it when needed.
Could you please tell me what kind of data was missing?

> Crappy HBAs and/or drivers, loose or dislodged cable connectors, and
> crappy active/passive backplanes are the primary movers when it comes to
> good drives dropping out of arrays.

In my case I don't use any HW Raid.
My motherboard is a MSI 870A-G54 - http://www.msi.com/product/mb/870A-G54.html and I only use SATA and software RAID.

> Again, I implore you to investigate all other portions of your storage
> stack before blowing money on drives, which may not be the cause of your
> problem.

It's really hard to find the source of the failure.
My first assumption was the drives, since I have 5 more (different) HDs connected to the board, two in RAID 1 (ATA drives) and they all work flawlessly.
Reading feedbacks from all the people complaining about the same issue with the SEAGATE drives as I have I automatically assumed there is a problems with these particular disks.


-- 

Marcin M. Jessa
```
