Hi,
I had similar errors to the problem reported in
http://marc.info/?l=linux-raid&m=118385063014256&w=2
Using manually coded patch similar to scsi fault injection
tests, I can reproduce the problem:
1. create degraded raid1 with only disk "sda1"
2. inject permanent I/O error on a block on "sda1"
3. try to add spare disk "sdb1" to the raid
Now raid code would loop to sync:
[ 295.837203] sd 0:0:0:0: SCSI error: return code = 0x08000002
[ 295.842869] sda: Current: sense key=0x3
[ 295.846725] ASC=0x11 ASCQ=0x4
[ 295.850081] Info fld=0x1e240
[ 295.852958] end_request: I/O error, dev sda, sector 123456
[ 295.858454] raid1: sda: unrecoverable I/O read error for block 123136
[ 295.864986] md: md0: sync done.
[ 295.903715] RAID1 conf printout:
[ 295.906939] --- wd:1 rd:2
[ 295.909649] disk 0, wo:0, o:1, dev:sda1
[ 295.913573] disk 1, wo:1, o:1, dev:sdb1
[ 295.920686] RAID1 conf printout:
[ 295.923914] --- wd:1 rd:2
[ 295.926634] disk 0, wo:0, o:1, dev:sda1
[ 295.930570] RAID1 conf printout:
[ 295.933815] --- wd:1 rd:2
[ 295.936518] disk 0, wo:0, o:1, dev:sda1
[ 295.940442] disk 1, wo:1, o:1, dev:sdb1
[ 295.944419] md: syncing RAID array md0
[ 295.948199] md: minimum _guaranteed_ reconstruction speed: 1000 KB/sec/disc.
[ 295.955262] md: using maximum available idle IO bandwidth (but not more than 200000 KB/sec) for reconstruction.
[ 295.965369] md: using 128k window, over a total of 71289063 blocks.
It seems to be caused by raid1.c:error() doing nothing in this fatal error
case:
/*
* If it is not operational, then we have already marked it as dead
* else if it is the last working disks, ignore the error, let the
* next level up know.
* else mark the drive as failed
*/
if (test_bit(In_sync, &rdev->flags)
&& conf->working_disks == 1)
/*
* Don't fail the drive, act as though we were just a
* normal single drive
*/
return;
Where is the code in "next level up" handling this? I'm using ancient 2.6.18,
can someone test whether this is the case for newer kernel?
I tested by commenting out those lines, but ends up with a raid1 consisting
of "sdb1" instead of total failure.
--
Bin