# Re: suns raid-z / zfs

- From: Bill Davidsen \<hidden\>
- Date: 2008-02-26 20:27:26 
- List: linux-raid
- Page: https://ratatoskr.run/linux-raid/2008/02/6602285
- Thread: https://ratatoskr.run/linux-raid/2008/02/6602221/t.md

```text
Keld Jørn Simonsen wrote:
> On Mon, Feb 18, 2008 at 09:51:15PM +1100, Neil Brown wrote:
>   
>> On Monday February 18, keld@dkuug.dk wrote:
>>     
>>> On Mon, Feb 18, 2008 at 03:07:44PM +1100, Neil Brown wrote:
>>>       
>>>> On Sunday February 17, keld@dkuug.dk wrote:
>>>>         
>>>>> Hi
>>>>>
>>>>>           
>>>>> It seems like a good way to avoid the performance problems of raid-5
>>>>> /raid-6
>>>>>           
>>>> I think there are better ways.
>>>>         
>>> Interesting! What do you have in mind?
>>>       
>> A "Log Structured Filesystem" always does large contiguous writes.
>> Aligning these to the raid5 stripes wouldn't be too hard and then you
>> would never have to do any pre-reading.
>>
>>     
>>> and what are the problems with zfs?
>>>       
>> Recovery after a failed drive would not be an easy operation, and I
>> cannot imagine it being even close to the raw speed of the device.
>>     
>
> I thought this was a problem with most raid types, while
> reconstructioning, performance is quite slow. And as there has been some
> damage, this is expected. And there probebly is no much ado about it.
>
> Or is there? Are there any RAID types that performs reasonably well
> given that one disk is under repair? The performance could be cruical
> for some applications.
>
>   
If that's a requirement, RAID1 with multiple copies would probably be your best best. You could probably design a test from existing software and a script, I'm just basing the thought on having run load on a recovering 4 way mirror at one time. The load was 100-250 random reads/sec, and response time stayed acceptable.
> One could think of clever arrangements so that say two disks could go
> down and the rest of the array with 10-20 drives could still function
> reasonably well, even under the reconstruction. As far as I can tell
> from the code, the reconstruction itself is not impeding normal
> performance much, as normal operation bars reconstuction operations.
>
> Hmm, my understanding would then be, for both random reads and writes
> that performance in typical raids would only be reduced by the IO bandwidth
> of the failing disks.
>
> For sequential R/W performance for raid10,f would
> be hurt, downgrading its performance to random IO for the drives involved.
>
> Raid5/6 would be hurt much for reading, as all drives need to be read for giving
> correct information during reconstruction.
>
>
> So it looks like, if your performance is important under a
> reconstruction, then you should avoid raid5/6 and use the mirrored raid
> types. Given you have a big operation, with a load balance of a lot of
> random reading and writing, it does not matter much which mirrored
> raid type you would choose, as they all perform about equal for random
> IO, even when reconstructing. Is that correct advice?
>
>   
>>>>> But does it stripe? One could think that rewriting stripes
>>>>> other places would damage the striping effects.
>>>>>           
>>>> I'm not sure what you mean exactly.  But I suspect your concerns here
>>>> are unjustified.
>>>>         
>>> More precisely. I understand that zfs always write the data anew.
>>> That would mean at other blocks on the partitions, for the logical blocks
>>> of the file in question. So the blocks on the partitions will not be
>>> adjacant. And striping will not be possible, generally.
>>>       
>> The important part of striping is that a write is spread out over
>> multiple devices, isn't it.
>>
>> If ZFS can choose where to put each block that it writes, it can
>> easily choose to write a series of blocks to a collection of different
>> devices, thus getting the major benefit of striping.
>>     
>
> I see 2 major benefits of striping: one is that many drives are involved and the other is that the stripes are  allocated adjacant, so that io
> on one drive can just proceed to the next physical blocks when one
> stripe has been processed. Dependent on the size of the IO operations
> involved, first one or more disks in a stripe is processed, and then the
> following stripes are processed. ZFS misses the second part of the
> optimization, In think.
>   


-- 
Bill Davidsen [ref]
 "Woe unto the statesman who makes war without a reason that will still
 be valid when the war is over..." Otto von Bismark



-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
```
