Hello linux-raid,
I have a home fileserver which used a 6-disk RAID5 array
with old disks and cheap IDE controllers (all disks are
IDE masters).
As was expected, sooner or later the old hardware (and/or
cabling) began failing. The array falls apart, in particular
currently it has 5 working disks and one marked as a spare
(which was working before).
The rebuild does not complete, because half-way through
one of the "working" disks has a set of bad blocks (about
30 of them). When the rebuild process (or the mount process)
hits these blocks, I get a non-running array with 4 working
drives, one failed and one spare.
While I can force-assemble the failing drive back into
the array, it's not useful - rebuild fails again and again.
Question 1: is there a superblock-edit function, or maybe
an equivalent manual procedure, which would let me mark the
"spare" drive as a working part of the array?
It [mostly] has all the data in correct stripes; at least
the event counters are all the same, and it may be a better
working drive than the one with bad blocks.
Even if I succeeded in editing all the superblocks to believe
that the "spare" disk is "okay" now, would it help in my data
recovery? :)
Question 2: the disk's hardware apparetly fails to relocate
the bad blocks. Is it possible for the metadevice layer to
do the same - remap and/or ignore the bad blocks?
In particular, is it possible for linux md to consider a
block of data as a "failed" quantum, not the whole partition
or disk, and try to use all 6 drives I have to deliver the
usable data (at least in some sort of recovery mode)?
--
Best regards,
Jim Klimov mailto:klimov@2ka.mipt.ru