The i2c-hid driver would quietly fail to probe the i2c-hid sensor-hub
with an ACPI device-id of SMO91D0 every other boot.
Specifically, the i2c_smbus_read_byte() "Make sure there is something at
this address" check would fail every other boot.
It seems that the BIOS does not properly reset/power-cycle the device
leaving it in a confused state where it refuses to respond to i2c-xfers.
On boots where probing the device failed, the driver-core puts the device
in D3 after the probe-failure, which causes the probe to succeed the next
boot.
Putting the device in D3 from the shutdown-handler fixes the sensors not
working every other boot.
This has been tested on both a Lenovo Miix 2-10 and a Dell Venue 8 Pro 5830
both of which use an i2c-hid sensor-hub with an ACPI id of SMO91D0.
Note that it is safe to call acpi_device_set_power() with a NULL pointer
as first argument, so on none ACPI enumerated devices this change is a
no-op.
Cc: Kai-Heng Feng <redacted>
Signed-off-by: Hans de Goede <redacted>
---
drivers/hid/i2c-hid/i2c-hid-core.c | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/drivers/hid/i2c-hid/i2c-hid-core.c b/drivers/hid/i2c-hid/i2c-hid-core.c
index dbd04492825d..b303a1dd0e3f 100644
--- a/drivers/hid/i2c-hid/i2c-hid-core.c
+++ b/drivers/hid/i2c-hid/i2c-hid-core.c
@@ -935,6 +935,11 @@ static void i2c_hid_acpi_fix_up_power(struct device *dev)
acpi_device_fix_up_power(adev);
}
+static void i2c_hid_acpi_shutdown(struct device *dev)
+{
+ acpi_device_set_power(ACPI_COMPANION(dev), ACPI_STATE_D3_COLD);
+}
+
static const struct acpi_device_id i2c_hid_acpi_match[] = {
{"ACPI0C50", 0 },
{"PNP0C50", 0 },@@ -949,6 +954,7 @@ static inline int i2c_hid_acpi_pdata(struct i2c_client *client,
}
static inline void i2c_hid_acpi_fix_up_power(struct device *dev) {}
+static inline void i2c_hid_acpi_shutdown(struct device *dev) {}
#endif
#ifdef CONFIG_OF@@ -1163,6 +1169,8 @@ static void i2c_hid_shutdown(struct i2c_client *client)
i2c_hid_set_power(client, I2C_HID_PWR_SLEEP);
free_irq(client->irq, ihid);
+
+ i2c_hid_acpi_shutdown(&client->dev);
}
#ifdef CONFIG_PM_SLEEP
--
2.28.0