On Wed, Jul 12, 2017 at 09:16:43AM +0200, Takashi Iwai wrote:

On Tue, 11 Jul 2017 21:58:21 +0200,
Paul Donohue wrote:

quoted

On Tue, Jul 11, 2017 at 05:50:07PM +0200, Takashi Iwai wrote:

quoted

Hi, just joining to the party in the middle, as I'm also facing the
same problem on Dell E7270 laptop.  Has this issue already been
addressed?

If not, the following was my result:

- the first patch slowed the pointer movement a lot, it's even slower
  than the old kernel (e.g. 4.4.x).
  The two finger scroll works fine on all touchpad area now.

- the second patch made the pointer movement even faster than now (as
  I feel, not quite sure).  The two finger scroll doesn't work at the
  right side of the touchpad.


The kernel output from the first patch is below:
  psmouse serio1: alps: test1 pitch 37x37 num-electrodes 8x7 physical size 25x22mm res 69x69 max 1792x1536

Let me know if you have any further test.


thanks,

Takashi

Do you have the kernel output from the second patch?

Here it is:

psmouse serio1: alps: test2 pitch 50x54 num-electrodes 20x11 physical size 95x54mm res 25x23 max 2432x1280

Thanks!

Wow, this is weird ... Values that cause scrolling issues for you work fine for me.

It looks like the priv->x_max value that is causing your problem, but perhaps you can confirm this with another test:
Revert the patches above, then just before the 'return' at the end of alps_update_device_area_ss4_v2() add the following line:
priv->x_max = 1792;
I suspect this line will make two-finger scrolling work again.

It might also help if you could experiment with other x_max values.  2432 is the correct value that causes problems for you..  Does a small value like 500 or a large value like 5000 change the behavior?

Another test you can try is to add a print statement in the 'case SS4_PACKET_ID_TWO' section of alps_decode_ss4_v2() and print out the f->mt[0].x and f->mt[1].x values.  With x_max set to 2432, what range of x values does this print when scrolling works, and what range of values are printed when scrolling doesn't work?

Thanks,
-Paul