[PATCH] video: fbdev: cyber2000fb: remove superfluous CONFIG_PCI ifdef

This is a PCI driver and FB_CYBER2000 depends on PCI in Kconfig so
there is no need to check for PCI inside the driver code.

Cc: Russell King <linux@armlinux.org.uk>
Signed-off-by: Bartlomiej Zolnierkiewicz <redacted>
---
 drivers/video/fbdev/cyber2000fb.c |    5 -----
 1 file changed, 5 deletions(-)

Index: b/drivers/video/fbdev/cyber2000fb.c
=================================--- a/drivers/video/fbdev/cyber2000fb.c

+++ b/drivers/video/fbdev/cyber2000fb.c

@@ -1642,10 +1642,6 @@ static void cyberpro_common_resume(struc
 }
 
 /*
- * PCI specific support.
- */
-#ifdef CONFIG_PCI
-/*
  * We need to wake up the CyberPro, and make sure its in linear memory
  * mode.  Unfortunately, this is specific to the platform and card that
  * we are running on.

@@ -1861,7 +1857,6 @@ static struct pci_driver cyberpro_driver
 	.resume		= cyberpro_pci_resume,
 	.id_table	= cyberpro_pci_table
 };
-#endif
 
 /*
  * I don't think we can use the "module_init" stuff here because

On 5/21/19 3:44 PM, Bartlomiej Zolnierkiewicz wrote:

This is a PCI driver and FB_CYBER2000 depends on PCI in Kconfig so
there is no need to check for PCI inside the driver code.

Cc: Russell King <linux@armlinux.org.uk>
Signed-off-by: Bartlomiej Zolnierkiewicz <redacted>

I queued the patch for v5.3.

Best regards,
--
Bartlomiej Zolnierkiewicz
Samsung R&D Institute Poland
Samsung Electronics